Craftsman 139.53989 User Manual

Browse online or download User Manual for Garage Door Opener Craftsman 139.53989. II:RRFI"$1UlRN`ILASER PARKER LOCATOR

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
II:RRFI"$1UlRN'ILASER PARKER LOCATOR
COMPLETE KIT CONTENTS (41A638) (1) Laser Parking Locator Swivel Mount (1) Power Pack
(1) Craftsman Control Module (1) Ceiling mount screw (2) Twist Ties (2) Caution Labels (1) Instructions
You will have 1 Laser Swivel Mount when purchasing the 139.53989 Garage Door Opener,
LASER ACCESSORY CONTENTS (41A638-1) (1) LaserParkingLocator Swivel Mount
(1) Ceiling Mount Screw (1) Twist Tie (2) Caution Labels (1) Instructions
The Laser Accessory must be used in conjunction with the Complete Kit
BEFORE YOU BEGIN Open your garage door, park your car(s) outside the garage and follow the
instructions below. The Power Pack, Control Module and Laser Parker Locator Swivel Mount require
connection by you.
CRAFTSMAN CONTROL i_;
MODULE
CEILING MOUNT SCREW
LASER PARKING
LOCATOR SWIVEL MOUNT
POWER PACK
INSTALLATION
1. Attach the Control Module by peeling off itsprotective seal and pressing firmly to the center of the back face
of the garage door opener according to the label. Note: See label on Control Module during installation.
Plug the laser into far right or far left plug on the control module.
2. Choose Location of Laser Swivel Mount. Mount the laser swivel mount on the ceiling toward the frontof the
vehicle. Attach the laser swivel mount to the ceiling using the supplied screw.
3. Plug the power pack into the same outletas the garage door opener.
NOTE: Surface must be fiat, clean, free of any oil, dirt and dry prior to attaching Laser Swivel Mount orControl Module.
Complete installationby tying together any loose wires with the included twistties.
1
Control ModuleLocation
SET UP AND ADJUSTMENT
1. Drive your car(s) into the garage and park in the exact location you want to park your car each time.
2. Activate the overhead garage door opener and the laser will emit a bright red spot. Using the swivel mount,
aim the red spot to a location on the dash or hood that you can easily see while seated in the ddvers seat.
NOTE: The laser will automatically shut off after approximately 1 minute. If you are not finished
adjusting the red spot and it turns off, simply activate your overhead automatic garage door opener
to re-activate the red spot.
3. Sit in the ddver's seat and confirm that you can easily see the red spot. This red spot location is now your point of
reference for parking in the exact location your car is currently parked. Repeat procedures with the optional 2nd laser
for your 2nd car.
CAUTION: To avoid eye injury, do not stare directly into the laser beam.
NOTE: Periodic adjustment of the red spot may be required from time to time and is to be used only with the vehicle used
dunng the initial set-up. For use with a different vehicle, you must re-set the adjustment according to SET UP and
ADJUSTING steps 1-3 for that vehicle.
OPERATION
1. Open thegaragedoorby activatingthe automaticgaragedooropeneranddrive inyourcar.
2. The redspotcan beseenmovingacrossthe hoodofyour car towardyouasyouddvefurtherintothegarage.
3. Stopthecar whentheredspotispositionedatthelocationyouconfirmedinstep3 duringthe Set up andAdjustment.
NOTE: The laseris automaticallyactuatedeverytimeyouactivateyour garagedooropener.The redspotwillautomatically
deactivateafterapproximatelyoneminute.A residualreflectionoftheredspotfrom thewindshield mayappearonthe walls
orobjectsinyourgarage.Whenoperatinga vehicle,alwaysensurethatthere are noobjectsonthefloorof thegarageorin
pathof yourvehicle.ThisLaserParkerLocatoris nota substituteforsafeparkingpractices.
2
2
3
CAUTION LABELS
Use tacks or staples to permanently attach an adhesive backed CAUTION label to wall near door control. Using the same method, mount the second label in a prominent location on the ceiling near the
Laser Swivel Mount
® Registered Trademark I TM Trademark I sm Service Mark of Sears, Roebuck and Co.
SAFETY INSTRUCTIONS
CAUTION:Toavoideyeinjuryordamagetoproduct:
Never point the laser at anyone.
Never look directly into the laser beam.
Never disassemble the laser.
Use of controls or adjustments, or the performance or procedures
other than specified can result in hazardous radiation exposure.
Only use this device with automatic garage door openers.
Exposure to extreme temperature may result in poor performance.
In the event you have any questions with the
assembly of the Laser Parker Locator or have any
damaged or missing parts please contact one of our
Technical Service Representatives at
1-800-528-5236.
The following accessory can be purchased at the
above number.
The LaserAccessory can be usedin conjunctionwiththe completekit
to positiona secondcarusingthe samegarage dooropener.
ITEM PART#
LaserAccessory 41A638-1
LASER TROUBLESHOOTING
If the laser does not emit a red spot:
1. Unplugthe PowerPack to verifythatthere is nopackingmaterial
obstructingthe laserlens.
2. Verifythatallconnections are secureas identifiedininstallation.
3. Confirmthatthe Laser ParkerSwivelMountis aimedtowardthe
garagefloor.
4. Activatethe garagedooropener.Lookfor the red spotonthe
garagefloor.
SPECIFICATIONS:
Laser:
Maximum Power Output: < lmw
WAVELENGTH: 635-670nm
CLASS II LASER PRODUCT
Power Supply:
3-6 volt DC
Indoor Use Only
114A2902
PRODUCT CAUTION LABELS:
t.AImt RAmA_mU
lie JmT m lift1 _
I.AIIEII RADIATION
DO NOT STARE INTO BEAM
IIIAEIIItlM I_WRN Qg31_31 < I mw II liall - Irnlmll
CLASS II LASER PRODUCT
Page view 0
1 2

Summary of Contents

Page 1 - LASER PARKER LOCATOR

II:RRFI"$1UlRN'ILASER PARKER LOCATORCOMPLETE KIT CONTENTS (41A638) (1) Laser Parking Locator Swivel Mount (1) Power Pack(1) Craftsman Contro

Page 2

I[RRFTSMRN'IGU[A SER PARA ESTACIONAMIENTOCONTENIDO DEL JUEGO COMPLETO (41A638) (1) Base glratorla de la gula ktser (1) Fuente de alimentacibn(1)

Comments to this Manuals

No comments