Craftsman 358.798141-28.0cc Operator's Manual download pdf (Page 19)

20. Pull thel2 inch slack in the ropeinto the inside ofthe

fan housing and catch rope in pulley notch. Fig-

ure29.

21.

Hold the rope taut andmake 2 complete on'as ofthe

pulley counterclockwise _ toplacetension on

the spring. Continue to hold the pulley to retain

tension.

22. Align pulley notch with rope exit hole, release

slack in the rope and pull starter handleto the full

extent of the rope. Release the pulley and slowly

a!low the rope to wind around the pulley.

23.

Reverse steps tore-assemble fan housing to shroud.

NOTE: Be sure to guide choke knob through the

hole in the fan housing during re-assembly.

-- II ii tl i i H III II

E DRIVE SHAFT LUBRICATION

• Lubricate the Flexible Drive Shaft:

-- After each ten (I0) hours of operation.

-- Before operating if the unit has been stored for

: 90 days or longer.

• Use Flex Shaft Lube Part No. 30102.

NOTE: A tube of "Flex Shaft Lube" has been supplied

with your unit to be used after the fast I0 hours of

operation.

Fignlt_ 29

• Use the following procedure for best results:

AW_G

If engine hasjust beenoperated, avoid toudah_ the muf-

tier. A hot muffler can cause serious burns.

IIIII III I II 11911 I II

[CAUTION: ] Lay the Flexible Drive Shaft on a clean

surface. Avoid laying the shaft on the floor, ground or

on any surface that may have dirt or debris, Even after

wiping theshaft, grease residue can pick up dirt par-

tides that can cause damage or premature failure.

3. Check the Flexible Drive Shaft for broken wires, twists

or kinks and replace if damage is found.

ICAUTION: ] Take care to avoid injuring your hands

and f'mgers with broken wires when checking for

damageorwiping the flexible drive shaft. A cloth will

not prevent the broken wires from puncturing or tear-

ing your skin.

4. Using a clean cloth, wipe the surface of the Flexible

Drive Shaft thoroughly to remove any old grease.

Figure 31.

5. Applyaurtiformcoat oflubetotheentire surfaceofthe

Flexible Drive Shaft.

I. Loosen (but do not remove) the.Clamp Bolt and

remove the Drive Shaft Housing from the Engine

Shroud. Figure 4:

2. Remove the Flexible Drive Shaft from the Drive

ShaftHousing as shown in Figure 30.

6. Injectthe remaining contcnts ofthe tube into the top of

the Drive Shaft Housing.

Z Replace Flexible Drive Shaft in the Drive Shaft

Housing.

8. Follow theinstructions in '_Lssembly" to replace Drive

Shaft Housing into the Engine Shroud.

WIPETHE _OF

THEFLEXIBLEDRIVE SHA_Pr

Figure 30 Figure 31

19 •

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Craftsman 358.798141-28.0cc Operator's Manual Page 19

Comments to this Manuals

Related products and manuals for Power tools Craftsman 358.798141-28.0cc