Craftsman 358.798141-28.0cc Operator's Manual download pdf (Page 11)

I IIIIIIHIII III 1 IIIIII I IIIIIIIIIIWII I III III IIIIIIIIIIIII 11 IIII[,,,m ii

D. OPERATING INSTRUCTIONS ."

t. Bring the engine to cutting speed before entering

the material to be cut.

L*.r

a. Do not run the engine at a higher speed than

•necessary. 1_e cutting line will cut efficiently when

the engine is run at less than full throttle. At lower

speeds, there is less engine noise and vibration. The

'trimmer line will last longer and will be less likely

to "'weld" on the spool.

b. If the Trimmer Head does not turn when the

engine is accelerated, make sure the Drive Shaft

• Housing is properly seated in the Engine Shroud.

Refer to '_ssembly-Drive Shaft Housing:'

2. Always releas e the Throttle Trigger and allow the

engine to return to idle speed when not cutting.

IIIIIII I IIIIIIIII I IIIIII

USING YOUR TRIMMER-

I IIIII IIIIIIIIIII I IIIIIII I IIII III

3. Make sure the Trimmer Head stops turning when

the Throttle Trigger is released and the engine runs

at idle speed. For correction, refer to "Carburetor

Adjustments"

4. To stop the engine:

a. Release the Throttle Trigger.

b. Push"Off" Button. HoM button down until the

engine stops. Figure 11.

Flgu¢_ 11

ii IIII ilU iiiiiiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiii

i Illllll II II _ = , II III _ [

II I I _/

AV0'ARNING " .THROW$OBJEL

The rapidly moving line causes objects to be thrown violently.

The shield will notprovidecompletepmtecfion to the operator

or others. The operator must wear a safety face sMeld or

goggles. Always wear heavy, long pants andbo0ts. Keep

others at least 30 feet away. : .

.'" f " .

AWARN•ING HAZASDZONE

This tool will throw objects and Cut. Keep others including

children, animals, bystanders and helpers at least 39 feet

away from the operator and tool. Stop the engine if yon are

approached.

Trimmer Head

#71-85764

Use Only Genuine Replacement Parts

WARNING ,- TZlM

Trimmer head parts that are chipped, cracked or damaged in

any way, can fly apart and cause serious injury. Do not use.

Replacedamaged parts before us'mg the tool.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Craftsman 358.798141-28.0cc Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Power tools Craftsman 358.798141-28.0cc