Craftsman 320.27680 Operator's Manual download pdf (Page 22)

Apply an even, downward pressure on the

plunge action until the cutter bit reaches the

desired depth, then move the plunge-lock

lever "down" to the locked position.

To raise the bit and the plunge action, unlock

the plunge-lock lever. The plunge action will

automatically retract from the workpiece and

return to the raised position.

Always have the plunge action in the raised

position and locked when the bit is not

cutting in the workpiece.

Plunge Action with Depth-Stop Rod and

Depth-Stop Turret (Fig. 9)

The depth-stop rod and the depth-stop turret

are used to control the plunge action cutting depth as follows:

Turn the motor off and unplug the router

from the power source.

Fig. 9

Place the router on a flat, level surface.

With the cutter bit already installed, lower

the plunge action until the cutter bit

makes contact with the flat, level surface

on which the router is sitting. Lock the

plunge-depth locking lever (F). This

position is zero "0": the point from which

further depth adjustments can be made.

To set a desired depth-of-cut, rotate the

depth-stop turret until the lowest step of

the turret (A) is aligned directly under the

depth-stop rod (B) (Fig. 9). Loosen the

depth-rod locking knob (C) and lower the

depth-stop rod until it contacts the lowest

step on the turret.

27683 ManuaLRevised_11-0120

Slide the clear plastic depth indicator (D) until the red line on the indicator is lined

up with zero "0" marked in black on the bottom of the depth scale. (This is now

indicating the point at which the bit makes contact with the workpiece).

To set a desired cutting depth, slide the depth-stop rod up until the red line

on the clear plastic depth indicator points to your desired cutting depth on

the depth scale (E). Secure the depth-stop rod at this position by tightening

the depth rod locking knob (C).

Unlock the plunge-depth-locking lever (F) to allow the bit to automatically

retract to the up position.

The desired depth-of-cut may now be achieved by plunging the router down

until the depth-stop rod contacts the selected step on the depth-stop turret.

Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Comments to this Manuals

No comments

Craftsman 320.27680 Operator's Manual Page 22

Comments to this Manuals

Related products and manuals for Power tools Craftsman 320.27680