Craftsman 320.27680 Operator's Manual download pdf (Page 16)

4. Press the spindle-lock button to engage

and lock the spindle shaft and collet/nut

(Fig. 3)

5. Place the wrench on the collet/nut and

turn it counterclockwise to loosen the

collet/nut slightly so it can accept cutter

bit shank.

6. Insert the cutter bit shank into the collet/

nut assembly as far as it will go, then

back the shank out until the cutters are

approximately 1/8 to 1/4 inch away from

the face of the collet/nut (Fig. 4, 4a).

NOTICE: To insure proper gripping of the

cutter bit shank and minimize run-out, the

shank of the cutter bit must be inserted into

the collet/nut at least 5/8 inch.

7. With the cutter bit inserted and the spindle

lock button pressed in to engage the

shaft, place the wrench on the collet/nut

and turn it clockwise until the collet/nut is

firmly tightened on the cutter bit.

_, WARNING: Tighten the collet/nut

securely to prevent the cutter bit from

slipping. If the collet/nut is not securely

tightened, the cutter bit may detach during

use, causing serious personal injury.

NOTICE: To prevent damage to the tool, do not

tighten the collet/nut without a cutter bit installed.

Removing the Cutter Bit from Fixed Base

1. Turn the motor off and unplug the router

from the power source.

Collet

Nut

Spindle Lock

Fig. 4 /_<'w_ \ Cutters

"_X_j Bit Shank

"J _ Spindle

Fig. 4a . Cutters

_/ Collet /

NOTICE: See the instructions for removing the motor housing from the fixed base.

2. Remove the motor from the fixed base.

3. Set the motor upside down on its top cap, with the collet/nut pointing up.

4. Press the spindle-lock button to engage and lock the spindle shaft and the

collet/nut (Fig. 3).

5. Place the wrench on the collet/nut and turn it counter-clockwise to loosen

the collet/nut slightly.

6. Remove the cutter bit shank.

Installing the Cutter Bit for Plunge Base

1. Turn the motor off and unplug the router from the power source.

2. Remove the motor housing from the plunge base.

27683 ManuaLRevised_11-O120 Page 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comments to this Manuals

No comments

Craftsman 320.27680 Operator's Manual Page 16

Comments to this Manuals

Related products and manuals for Power tools Craftsman 320.27680