Craftsman 172.21299 Operator's Manual download pdf (Page 29)

I WARNING: ALWAYS wear safety goggles or safety glasses with side shields

when using this tool or blowing dust. If operation

is dusty, also wear a dust mask.

I II I I I I I I I I I I

LUBRICATION

All of the bearings in this tool are lubricated at the factory with a sufficient amount of

lubricant. Therefore, no further lubrication is required.

On all mechanical parts of your table saw where a pivot or threaded rod are present,

lubricate using graphite or silicone. These dry lubricants will not hold sawdust like oil or

grease would.

Sears offers a large selection of blades, table extensions, roller tables, extension cords and

more that are ideal for use with your 10-inch Table Saw for a variety of cutting needs.

i i

A, WARNING: The use of attachments or accessories not sold by Sears may ]

result in serious personal injury.

EXTENSION CORDS

The use of any extension cord will cause some loss of power. To keep the loss at a

minimum and to prevent overheating, use an extension cord that is heavy enough to

carry the current that the tool will draw.

A wire gauge (AWG) of at least 14 is recommended for an extension cord 25 feet or less

in length. When working outdoors ALWAYS use an extension cord that is suitable for

outdoor use. The cord's jacket will be marked WA.

i J in i i i i ii ii i

/_ CAUTION: Keep extension cords away from the cutting area, and position the I

cord so it will not get caught on lumber, tools, etc. during the cutting operation.

i i i

! i i i i

WARNING: Check extension cord before each use. If damaged, replace it !

immediately. NEVER use a tool with a damaged cord because touching the damagec

area could cause electrical shock, resulting in serious injury. II

II I I I

1 2 ... 24 25 26 27 28 29 30 31 32

No comments

Craftsman 172.21299 Operator's Manual Page 29