Craftsman 172.21299 Operator's Manual download pdf (Page 17)

MOUNTING SAW TO WORK SURFACE (See Figure 4)

I I I I II III I I

WARNING: ALWAYS make sure your table saw is securely mounted to a

workbench or an approved work stand. Failure to do so could result in an accident,

resulting in possible serious personal injury.

i i i

i i ]

DANGER: DO NOT operate this tool on the floor. This is very dangerous and

may cause serious injury.

1. This saw must be properly and securely mounted

to a sturdy work surface using the 4 mounting

holes at the base of the saw.

2. The surface of the work surface where the saw

will be mounted should have a hole large enough

to facilitate sawdust fall-through and removal.

3. Square the saw on the work surface and mark the

location of the four mounting holes..

4. Drill a 3/8-in. hole into each of the 4 mounting hole

locations marked on the mounting surface.

5. Mark an 11-inch square centered between the

4 mounting holes.

6. Cut out and remove the square.

7. This opening will allow sawdust to fall through

the saw base.

Fig. 4

Square Cutout

8. Place the saw on the work surface, and align the holes on the saw with those drilled

through the surface

9. Securely mount the saw to the work surface.

ATTACHING THE HANDLE TO BLADE

ELEVATING WHEEL (See Figure 5)

1. Place handle bolt into hole on handle and

tighten securely.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Craftsman 172.21299 Operator's Manual Page 17