Craftsman 172.21299 Operator's Manual download pdf (Page 21)

ADJUSTING THE 90° AND 45° POSITIVE STOPS (See Fig. 13-14)

Your saw has positive stops that will quickly position the saw blade at 90° to the table.

Make adjustments only if necessary.

90° STOP

1. Unplug the saw.

I I I [ I I I I

WARNING: To prevent personal injury, ALWAYS disconnect the plug from

power source BEFORE assembling parts, making adjustments or changing blades.

I ii I I I _,,_

2. Turn blade elevation hand wheel counter-

clockwise to raise the blade to maximum height.

3. Loosen the blade bevel lock knob and move the

blade to the maximum vertical position.

Re-tighten lock knob.

4. Place a combination square on the table and

against the blade to determine if the blade is 90°

to the table.

5. If blade is not 90° to the table, loosen the 2 set

screws located on the collar underneath the table

saw with the hex key and loosen the collar.

6. Loosen the bevel lock knob. Move the blade tilting wheel and move the blade until it is

90° to the table,

7. Adjust the collar so that it is in contact with the bracket when the blade is 90° to the table.

8. Tighten the 2 set screws.

45° STOP

1. Unplug the saw.

WARNING: To prevent personal injury, ALWAYS disconnect the plug from

power source BEFORE assembling parts, making adjustments or changing blades.

2. With the blade in the upright 90 ° position, loosen

the bevel lock knob and move the blade to the

45 ° position as far as it will go.

3. Place a combination square on the table to check

if the blade is 45 ° to the table.

4. If blade is not 45 ° to the table, loosen the 2 set

screws located on the collar underneath the

table saw with the hex key and loosen the collar.

5. Re-tighten the bevel lock knob and secure the

screw until resistance is felt.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Craftsman 172.21299 Operator's Manual Page 21