BEVEL CROSSCUTTING 0°- 45 ° BLADE BEVEL, 90° MITER ,ANGLE (See Figure 21)
This operation is the same as crosscutting, except
the blade is at a bevel angle other then 0°.
1. Adjust blade to the desired angle and tighten the
blade bevel lock lever
2. Tighten miter lock handle at 90°.
COMPOUND MITER CROSSCUTTING
(See Figure 22)
This operation combines a miter angle with a bevel angle.
i
WARNING: ALWAYS work to the left side of the blade during this type of cut.
The miter gauge must be in the left side miter groove.
0° - 45 ° BLADE BEVEL, 0° - 45 ° MITER ANGLE
1. Set the miter gauge to the desired angle.
Use only the left side groove.
2. Set the blade I::eve;to the desired angle.
3. Carefully push the miter gauge to begin the
cutting operation.
Fig. 22
27
Comments to this Manuals