Craftsman 172.21299 Operator's Manual download pdf (Page 19)

TO REPLACE BLADE (See Figs. 7 - 9) cont.

5. Remove the arbor nut and the outer flange.

6. Install a new blade on the arbor with the blade

teeth pointing towards front of saw.

7. Install the flange against the blade and thread

the arbor nut as far as possible by hand. Be sure

the blade is flush against the inner side of the

blade flange.

MITER GAUGE ADJUSTMENT (See Fig. 10)

1. Unplug the saw.

WARNING: Topreventpersonalinjury,

ALWAYS disconnect the plug from power

source BEFORE assembling parts, making

adjustments or changing blades.

2. Make sure the miter gauge will slide freely

through both table grooves.

3. Loosen the lock knob. Set the miter head to 90 °.

4. Adjust the pointer to 90 ° on the miter gauge scale.

NOTE: The miter gauge is designed with positive stops every 15° for accuracy.

RIP FENCE ADJUSTMENT (See Fig. 11)

1. Unplug the saw.

WARNING: To prevent personal injury, ALWAYS disconnect the plug from

power source BEFORE assembling parts, making adjustments or changing blades.

2. The fence is moved by lifting up the locking

handle and sliding the fence to the desired

location. Pushing down on the handle locks the fence in position.

3. Position the fence on the table and along one edge of the miter gauge grooves.

4. Lock the fence handle. The fence should be parallel with the miter gauge grooves.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Craftsman 172.21299 Operator's Manual Page 19