Craftsman 113.221611 Owner's Manual download pdf (Page 14)

TO LOWER EXTENSION

!. If extension is too high loosen four screws on

underside of the extension D, E, F, and G. See

illustration.

2 Tighten screws A, B and C on top of table

extension to lower extension even with table top

front and rear.

3. Check height with square and tighten screws D,

E, F and G

4. Repeat for left extension.

,,,u,

EXTENSfON

LEVELING EXTENSIONS

Place combination square on table and extension so

that end of blade extends over edge of extension.

HoLd square firmly on saw table and check for gap

between extension and blade of square.

SHOULD BE

NO GAP

TO LOWER OUTER EDGE OF EXTENSION

1. Loosen screws B_E, and Fon right extension. See

ilhJstration

2 Tighten screws C, D, and G until table extension

is Level

3oSnug down screws B, E, and Fr.

4 Repeat for left extension

EXTENSION

TO RAISE OUTER EDGE OF EXTENSION

1 Loosen screws C, D, and G on right extension.

2. Tighten screws B, E, and F until table extension is

tevet

3. Snug down screws C, D, and G

4. Repeat for left table extension.

EXTENSION

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Craftsman 113.221611 Owner's Manual Page 14