Craftsman 113.221611 Owner's Manual download pdf (Page 11)

ADJUSTING 90 DEGREE BEVEL STOP

1 On the stop bracket are two t0-32 pan head

screws which set 90° stop position. If condition A

exists the two screws need to be turned clockwise

to obtain 90° setting if condition B exists the

stews should be turned counterclockwise

[ t/BLADE

I I.,.,.,,-'_BLADE

2.. Turn saw over

3, Rotate bevel crank blade is in approximateFy 40°

position and using phillips screwdriver rotate

screws slightly in direction necessary to correct

gap, (rotate screws equally),. Recheck blade

position and readjust if necessary

4, When 90° stop position is adjusted to your

satisfaction re-adjust pointer to 0° position,

BEVEL

STOP BRACKET

BEVEL SHAFT X_

BEVEL ADJUSTING

SCREWS

BEVEL

HANDWHEEL

ADJUSTING BEVEL POINTER

If blade IS SQUARE to table:

1,, Check pointer.

If POINTER DOES NOT point to the "0" mark on the

bevel scale:

2 Remove Elevation Handwheel

3 Loosen screw and adjust pointer using

medium screwdriver

4o Install Elevation Handwheel

! r

BEVEL

POINTER

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Craftsman 113.221611 Owner's Manual Page 11