Craftsman 113 Owner's Manual download pdf (Page 17)

5. Fromamongthe looseparts,find the following

hardware:

4 CarriageBolts,5/16-18x 3/4in.long

4Hex.Nuts,5/16-18

(approx,dia.ofhole5/16in.)

4 Lockwashers,5/16in,ExternalType

(approx.dia.ofhole5/16in.)

6. PlacemotoronMOTORBASE... insertboltsthrough

holesin base... thenthroughthemotor.Install

Iockwashers,andnuts.

7. Positionmotorsothatedgeof MOTORFOOTand

MOTORBASEareeven.,,slidemotorallthewayto

theRIGHT,..tightenthefournuts.

8. Loosenset screwin motorpulleyusing5/32 in.

setscrewwrench.SlidepulleyonshaftwithHUBaway

frommotor.DONOTTIGHTENSETSCREW.

9. Install 3/16" in. square key (furnished with motor) in

grooves in pulley and motor shaft. DO NOT TIGHTEN

S ETSC R EW.

LOCKWASHER

._/16IN.

NUT !}

5/16-]8

SHAFT ',i ./

GUARD

THESE 1WO

EDGES EVEN

KEY

CARRIAGE BOLT

5/16-1_ X 3/4 iN.

BASE

MOTOR MOUNTING

BASE

ULLEY

10. Lift motor and insert the TWO PINS on motor base

into HOLES in cradle ... push motor in as far as it will

go.

11. Lower the blade.. ,install be:t on saw pulley and motor

pulley.

12. Sight along edges of both pulleys arid move motor

pulley so that belt is parallel to the edges of both

pulleys.. ,tighten the setscrew in the motor pulley.

13. IMPORTANT: Measure the distance from end of motor

shaft to pulley...mark this dimension down; you will

need it later when reinstalling the pulley.

14. Make sure blade is g0 ° to table.. ,raise it all the way

up.

15. Lift motor until edge of washer is even with end of slot

... tighten pivot screw. In this position, pull motor

toward you (pins will slide out of cradle) until belt is

TIGHT ... tighten the two MOTOR BASE CLAMP

SCREWS.

16. Loosen Pivot Screw slightly,

17. Lower the saw blade all the way down.

18. IMPORTANT: Motor should pivot freely downward as

blade is lowered. If it does not, LOOSEN the PIVOT

SCREW some more.

19. Pivot screw must be adjusted only tight enough to allow

motor to pivot FREELY as blade is raised or lowered.

This will maintain constant tension on belt.

EDGE OF WASHE_

EVEN WITH END

OF SLOT

PIVOT SCREW

MOTOR PULLEY

BASE

CLAMP SCREWS

20.

Loosen the two MOTOR CLAMP SCREWS on each

end of motor. Rotate the motor so that the

CAPACITOR COVER is on top.., tighten the screws.

The ventilation holes are now facing downward which

will help prevent sawdust from entering motor.

CAPACITOR

COVER

VENTILATION

HOLES

MOTOR

CLAMP SCREW

(BOTH ENDS)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments

Craftsman 113 Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Power drills Craftsman 113