Craftsman 973.271830 Owner's Manual

Owner's ManualIP R O F E S S I O H AL _Variable Speed / ReversiblePROFESSIONAL 3/8 in.CORDLESS DRILL-DRIVERModel No.973.271830Save this manual fo

INSTALLING BITSSee Figure 8.Lock the switch trigger by placing the direction ofrotation selector in center position. See Figure 2.Open or close chuck

Note: Remember the two-speed feature (HI-LO) whensetting torque. The amount of torque will vary depend-ing on which speed setting you have your drill-

CHUCK REMOVALSee Figures 14, 15, and 16.The chuck must be removed in order to use someaccessories. To remove:• Lock the switch trigger by placing the

_k WARNING:Whenservicing,useonlyidenticalCraftsmanreplacementparts.Useof anyotherpart may create a hazard or cause productdamage.Avoid using solvents

Topreservenaturalresources,pleaserecycleordisposeofproperly.Thisproductcontainsnickel-cadmiumbatteries.Local,stateorfederallawsmayprohibitdisposalofni

ICRAFTSMAN PROFESSIONAL 318 in. CORDLESS DRILL-DRIVERMODEL NO, 973.271830IThe model number will be found on a plate attached to the motor housing. Alw

In U.S.A. or Canadafor in-home major brand repair service:Call 24 hours a day, 7 days a week1-800-4-MY-HOM E" (1-800-469-4663)Para pedir servicio

• Warranty ...

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, andthe explanations with them, deserve your carefu

RULES FOR SAFE OPERATION (Continued)NEVER USE IN AN EXPLOSIVE ATMO-SPHERE. Normal sparking of the motor couldignite flammable liquids, gases, or fumes

RULES FOR SAFE OPERATION (Continued)• An extension cord should not be used unless •absolutely necessary. Use of improperextension cord could result in

Thefollowingrecommendedaccessoriesarecurrentlyavailableat SearsRetailStores.• 6-Pc.ExtraLengthMagnitePowerBitSet • HighSpeedBits(ForWoodorMetal)..3/4i

_ WARNING: Always wear safety goggles orsafety glasses with side shields when operatingtools. Failure to do so could result in objectsbeing thrown int

SWITCHSee Figure 2.To turn your drill ON, depress the switch trigger. Toturn it OFF, release the switch trigger.CENTERPOSITION L mJ(LOCK) _---'J

SWITCH LOCKSee Figure 5.The switch trigger can be locked in the OFF position.This feature can be used to prevent the possibility ofaccidental starting