Craftsman 54930 Owner's Manual download pdf (Page 32)

Features

Your garage door opener is equipped with features to provide you

with greater control over your garage door operation.

REMOTE CONTROLS AND DOOR CONTROLS

Your garage door opener has already been programmed at the

factory to operate with your remote control, which changes with

each use, randomly accessing over 100 billion new codes. Older

Craftsman accessories are not compatible.

Accessories MEMORY CAPACITY

Remote Controls

Up to 8

Door Controls

Up to 2 door controls.

Keyless Entries

Up to 1

THE PROTECTOR SYSTEM

(SAFETY REVERSING SENSORS)

When properly connected and aligned, the safety reversing

sensors will detect an obstruction in the path of the infrared

beam. If an obstruction breaks the infrared beam while the door is

closing, the door will stop and reverse to full open position, and

the opener lights will flash 10 times. If the door is fully open, and

the safety reversing sensors are not installed, or are misaligned,

the door will not close from a remote control. However, you can

close the door if you hold the button on the door control or

keyless entry until the door is fully closed. The safety reversing

sensors do not effect the opening cycle.

ENERGY CONSERVATION

For energy efficiency the garage door opener will enter sleep mode

when the door is fully closed. The sleep mode shuts the garage

door opener down until activated. The sleep mode is sequenced

with the garage door opener light bulb; as the light bulb turns off

the sensor LEDs will turn off and whenever the garage door

opener lights turn on the sensor LEDs will light. The garage door

opener will not go into the sleep mode until the garage door

opener has completed 5 cycles upon power up.

LIGHTS

The garage door opener light bulbs will turn on when the opener

is initially plugged in; power is restored after interruption, or when

the garage door opener is activated. The lights will turn off

automatically after 4-1/2 minutes. An incandescent A19 light bulb

(100 watt maximum) or for maximum energy efficiency a 26W

(100W equivalent) compact fluorescent light (CFL) bulb may be

used.

Using Your Garage Door Opener

The garage door opener can be activated through a wall-mounted

door control, remote control, or wireless keyless entry.

When the door is closed and the garage door opener is activated

the door will open. If the door senses an obstruction or is

interrupted while opening the door will stop. When the door is in

any position other than closed and the garage door opener is

activated the door will close. If the garage door opener senses an

obstruction while closing, the door will reverse. If the obstruction

interrupts the sensor beam the garage door opener lights will

blink 10 times. However, you can close the door if you hold the

button on the door control or keyless entry until the door is fully

closed. The safety reversing sensors do not affect the opening

cycle.

The safety reversing sensor must be connected and aligned

correctly before the garage door opener will move in the down

direction.

Using the Door Control

Press the lighted push button to open or close the door. Press

again to reverse the door during the closing cycle or to stop the

door while it's opening.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 75 76

Comments to this Manuals

No comments

Craftsman 54930 Owner's Manual Page 32

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 54930