Craftsman 113.221740 Specifications download pdf (Page 29)

When"width ef rip" is narrower than 2", the push stick

cannot be used because the guard wilt interfere° Use the

auxiliary fence and push block for' this ripping operation.

Attach auxiliary fence to rip fence with two "C" clamps_

Auxiliary Work Support/Fence

Feed the workpiece by hand along the auxiliary fence

until the end is approximately 1" past the front edge of the

table° Continue to feed using the push block.

Hold the workpiece in position and install the push block

by sliding it on top of the auxiliary fencelwork support.

This may raise the guard..

Push B

I WARNING: To avoid injury from blade contact]

never perform thru-saw cuts narrower than 112"

wide.

Narrow strips thicker than the auxiliary fence/work sup-

port may enter the guard and strike the baffle. Carefully

raise guard only enough to clear the workpiece. Use

push block to complete cut.

Baffl

Bevel Ripping

When bevel ripping material 6" or narrower, use fence on

the right side:of the blade onlyo This_will provide mere

space between the fence and the sawblade for use of a

push stick.. If the fence is mounted to the left, the saw-

blade guard may interfere with proper use of a push stick.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Craftsman 113.221740 Specifications Page 29