Craftsman 113.221740 Specifications download pdf (Page 16)

Adjusting Blade Parallel to Miter Gauge Groove

I WARNING: To avoid injury from accidental start,]

make sure switch is "OFF" and plug is not con-I

netted to power source outlet.

CAUTIoN: Fold a piece of cardboard over the blade j

1.,Unplug the saw.,

NOTE: Always review the section "Checking Blade Paral_

lel to the Miter Gauge Groove" before proceeding with

this section,

2, Loosen 1/2 turn the four alignment screws (A) in the

top of table next to the sawblade.. This will allow the

mechanism below the table to be shifted sideways°

3, Fold a piece of cardboard over' the blade to protect

your hands_

4.,Grasp the blade and the spreader support mechanism

and move it to either' the right or left a small amount as

needed to make the square touch the same amount

front and rear. Tighten one screw.

5, Check with square to determine if marked tooth

touches square by the same amount at front and rear.

If it does, alternately tighten the other three screws

slowly.

If it does not, loosen screws and move blade the

required amount.

NOTE: If adjustment cannot be achieved by loosening

the four alignment screws (A), loosen the two second-

ary alignment screws (B) only if it is absolutely neces-

sary to make this adjustment,

6. Recheck blade clearance to table and table insert to

make sure blade does not hit at both 90 and 45 degree

blade tilt.

Secondary

Alignment

Screws (B)

illllll

Alignment

Screws (A)

oard_

Removing Sawblade

WARNING: To avoid injury from accidental start, !

make sure switch is "OFF" and plug is not con-

nected to power source outlet.

l_Unplug the saw_

2. Remove blade guard and retain hardware°

3. Remove the phillips head screws from the blade insert.

4. Lift the blade insert noting that the formed edge is

toward the blade_ Set insert aside._

5. Turn elevation handwheel clockwise to raise sawblade

as high as it w{!l go..

6. Insert open end arbor shaft wrench over ttat portions of

motor spacer' and closed end arbor' nut wrench over

arbor nut. Position wrenches as shown, holding your'

hands well above blade°

7oHold arbor wrench against table and loosen arbor'nut

with arbor nut wrench by pulling it forward to you.

B. Slide sawblade off motor shaft°

Open End Arbor' .L._oosen

Shaft Wrench\ "_'-_._ ._-_ Closed End

. Arbor Nut

Wrench

---. .,

Stop on Table _" /

Formed Edge

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Comments to this Manuals

No comments

Craftsman 113.221740 Specifications Page 16

Comments to this Manuals

Related products and manuals for Flat panel accessories Craftsman 113.221740