Craftsman 113.221740 Specifications download pdf (Page 14)

Blade Tilting Control and LOck Lever Adjustment

1. Loosen blade tilting lock lever and slide the _eievation

handwheel until blade is at desired angle and tighten

blade tilt locklever_

2. If blade lock lever' intederes with sorne object before

blade tilting control mechanism is held tight or rigid,

pull lock lever out and rotate lock lever counterclock-

wise to another position.. Tighten lock lever..Recheck

for proper adjustment of blade tilt lock lever

3_ If rock lever won't loosen enough so blade can be tilled,

pull lock lever out and rotate lever clockwise to another

position,. Tighten blade lock lever

iiiiiiii ii iii , i,

.Elevation Handwheei

Blade Tilt Lock Lever

Adjusting 90 and 45 Degree Positive Stops

Your saw is equipped with positive stops for fast and

accurate positioning of the sawblade at 90 and 45

degrees to the table.. Always measure blade position from

the left side of the blade,. Blade insert may not .be flush

with table top.

WARNING: To prevent personal injury, always dis-

connect plug from power source when making

adjustments.

Adjusting Positive Stop at 90 Degrees

1_Unplug the saw.. "_"

2. Turn elevation wheel clockwise and raise blade to max-

imum height,

3o Loosen the blade tilt lock lever and push the elevation

wheel to the left as far as possible and tighten the

blade tilt lock lever..

4. Place a combination square on the table with one end

of square against the blade as shown and checkto see

if the blade is g0° to the table.,

5,.If the blade is not 90 ° to the table, loosen the blade tilt

lock lever, loosen 90° adjustment screw (A) a few turns

and push the elevation wheel until the blade is 90° to

the table.

6. Tighten blade tilt lock lever and tighten 90° adjustment

serew until it stops..

r i

90° Adjustment Screw (A)

Adjusting Positive Stop at 45 Degrees

1..Loosen the blade tilt lock lever and push elevation

wheel to the right as far as possible and tighten the

blade tilt lock lever.

2.. Place a combination square on the table with one end

of the square against the table as shown, and check to

see if the blade is 45" to the table.

3o tf the blade is not 45 ° t0 the table, loosen the blade tilt

lock lever, loosen 45 ° adjustment screw(B) a {ew turns

and push the elevation wheel until tile blade is 45° to

the table.

4. Tighten blade tilt lock lever and tighten 45 ° adjustment

screw until it stops..

Blade Insert

45 _ Adjustmen

Screw (B)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Comments to this Manuals

No comments

Craftsman 113.221740 Specifications Page 14

Comments to this Manuals

Related products and manuals for Flat panel accessories Craftsman 113.221740