Craftsman 139.18987 Owner's Manual download pdf (Page 18)

Installation Step 6

Install the Premium Control Console

Do not connect to live electrical wiring.

Connect only to 24 Volt low voltage wires.

Connection to live wires or higher voltage may

cause serious injury from shock, burn or

electrocution.

Children operating or playing with a garage

door opener can injure themselves or others.

The garage door could close and cause

serious injury or death.

Install the door control (or any additional push

buttons) out of the reach of children and away

from all moving parts of the door and door

hardware,

but where the garage door is visible.

Do not allow children to operate the push

button(s) or the remote control(s).

A moving garage door could injure someone

under it.

Activate the opener only when the

door is properly adjusted, you can see it clearly,

and there are no obstructions to door travel.

WARNING

Locate the door control within sight of the door

at a minimum height of 5 feet where small

children cannot reach, and away from all moving

parts of the door and door hardware.

The door control is typically attached directly to the

wall. If installing into drywall, drill 5/32" holes and

use the anchors provided.

For pre-wired installations

(as in new home construction), Console models

may be mounted to a standard single gang box

(Figure 2).

1. Strip 1/4" of insulation from one end of the bell

wire and connect it to the two screw terminals on

the back of the door control: white to 2, and

white/red to 1.

2. Pry off cover along one side with a screwdriver

blade (see Figure 1). Fasten with 6ABx1-1/4" self-

tapping screws (standard installation) or 6-32x1"

machine screws (pre-wired installation) as

follows:

• Install bottom screw, allowing 1/8" to protrude

above wall surface.

• Position bottom of door control on screw head

and slide down to secure. Adjust screw for snug

fit.

• Drill and install top screw with care to avoid

cracking plastic housing.

Do not overtighten.

• Insert top tabs and snap on cover.

(For standard installation only)

Run the bell wire

up the wall and across the ceiling to the opener.

Use insulated staples to secure the wire in

several places. Be careful not to pierce the wire

with a staple, creating a short.

4. Connect the bell wire to the terminal screws on

the opener panel: white to 2; white/red to 1.

5. Position the antenna wire as shown.

Antenna

Opener

Terminal Screws

2-Conductor

Bell Wire

2 3

Lock

Light

Lighted

Push Button

LOCK

LIGHT

Terminal

Screws

Top

Mounting

Hole

Bottom

Mounting

Hole

PREMIUM CONTROL CONSOLE

BACK VIEW

WHITE

RED

Dry Wall Anchors

Insulated

Staples

6AB x 1-1/4" Screw

Control Console (std installation)

6-32 x 1" Screw

Control Console (pre-wired)

Hardware Shown Actual Size

To Replace,

Insert

Top Tabs

First

To Remove,

Twist

Here

PRE-WIRED

INSTALLATION

REMOVE & REPLACE COVER

LOCK

LIGHT

Figure 1 Figure 2

24 Volt

2-Conductor

Bell Wire

1 ... 17 18 19 ... 40

Comments to this Manuals

No comments

Craftsman 139.18987 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 139.18987