Craftsman C935.51850 Operations Instructions download pdf (Page 8)

advancedautomaticlinefeeding

mechanismsenseswhenmorecutting

lineisneededandfeedsandtrimsthe

correctlengthoflinewheneverit's

required.DONOTBUMPuniton

groundinattempttofeedlineorfor

anyotherpurposes.

FITTING A NEW SPOOL OF AFS

CU'I-I'ING LINE (FIGURES 11 & 12)

• Unplug the tool.

• Depress the tabs (a) and remove the

cassette (b) from the cassette housing

(c) in the trimmer head (figure 11}.

@

am

• Grasp empty spool (d) with one hand

and cassette with other hand and pull

spool out from cassette. If lever (e) in

base of cassette becomes dislodged,

replace in correct position before

inserting new spool into cassette.

• Remove any dirt and grass from the

cassette and housing.

• Take the new spool and push it onto

the boss (f) (figure 12) in the cassette.

Rotate the spool slightly until it is seated.

• Unfasten the end of one of the cutting

lines and guide the line into one of the

eyelets (g) (figure 12}. The line should

protrude approximately 4-3/8 inches

(111mm) from the cassette.

• Unfasten the end of the other cutting

line and guide the line into the other

eyelet. The line should protrude

approximately 4-3/8 inches (111mm)

from the cassette.

• Align the cassette tabs (a) with the slots

(h) in the housing (figure 11).

• Push the cassette onto the housing

until it snaps securely into place.

CAUTION: To avoid tool damage, If the

cutting lines protrude beyond the

trimming blade (i), cut them off so that

they just reach the blade (figure 11).

N

WINDING NEW LINE ONTO AN

EMPTY SPOOL (FIGURES 13 &14)

You may wind new cutting line onto an

empty spool. Replacement packs of .065

inch (1.65 mm) cutting line are available

from your Sears store.

• Remove the empty spool from the tool

as described in "FITTING A NEW

SPOOL OF AFS CUTTING LINE".

• Remove any remaining cutting line

from the spool.

• First wind new line onto the uppermost

part of the spool.

- Feed 3/4 inch (19mm) of cutting line

into one of the line anchoring slots.

- Wind the cutting line onto the spool in

the direction of the arrow on the spool.

Make sure to wind the line neatly and in

layers. Do not crisscross (figure 13).

O

,/

X

- When the wound cutting line reaches

the recesses (j), cut the line. (figure 14).

- Temporarily park the line in the holding

slots (k) on one side of the spool as

shown in the inset in figure 14.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments