Craftsman C935.51850 Operations Instructions download pdf (Page 5)

ASSEMBLY TOOLS REQUIRED (NOT

SUPPLIED):

- Phillips Screwdriver

ATTACHING THE TWO PIECE

GUARD

_t,WARNING: UNPLUG THE TOOL

BEFORE ATTEMPTING TO ATTACH

THE GUARD. NEVER OPERATE TOOL

WITHOUT GUARD FIRMLY IN PLACE.

THE GUARD MUST ALWAYS BE ON

THE TOOL TO PROTECT THE USER.

• Remove the two guard sections from

the carton.

• Attach the first guard section with side

tab into the groove around the housing

as shown in figure 1. Align the hole in

the guard with the post on the trimmer

housing.

O

• Insert the side tab from the first guard

section into the slot of the second guard

section until you hear them "snap"

together (figure 3).

Tab

Remove the screw from the second

guard section.

• Insert the top tab from the second

guard section into the first guard

section as shown in figure 2. NOTE:

The rib behind the tab should be

hooked over the rib of the first guard

section. (See inset figure 2).

Rib

• Insert the 3/4inch (19mm) screw as

shown in figure 4 to complete the guard

assembly.

O

• Once the guard is installed, remove the

covering from the line cut-off blade,

located on the edge of the second guard

section.

ATTACHING THE AUXILIARY

HANDLE

• Attach the handle to the metal shaft of

the trimmer by pushing it onto the shaft

from the side. Once it is pushed onto

the metal shaft, the handle can be

turned into the correct orientation.

• Insert the 2-1/2 inch (63.5mm) bolt

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments