Craftsman 900.277300 Operator's Manual download pdf (Page 3)

be caughtin movingparts. Rubber

glovesand non-skidfootwearare

recommendedwhenworking

outdoors.Wearprotectivehair

coveringto containlong hair.

• USE SAFETY GLASSES. Also

use face or dust mask if operation

is dusty.

• DON'T ABUSE CORD. Never carry

tool by cord or yank it to disconnect

from receptacle. Keep cord from

heat, oil, and sharp edges.

• SECURE WORK. Use clamps or a

vise to hold work. It's safer than

using your hand and it frees both

hands to operate tool.

• DON'T OVERREACH. Keep proper

footing and balance at all times.

• MAINTAIN TOOLS WITH CARE.

Keep tools sharp and clean for

better and safer performance.

Follow instructions for lubricating

and changing accessories. Inspect

toot cords periodically and if

damaged, have repaired by

authorized service facility. Inspect

extension cords periodically and

replace if damaged. Keep handles

dry, clean, and free from oil

and grease.

• DISCONNECT OR LOCK OFF

TOOLS when not in use, before

servicing, and when changing

accessories, such as blades,

bits, cutters.

• REMOVE ADJUSTING KEYS AND

WRENCHES. Form habit of

checking to see that keys and

adjusting wrenches are removed

from tool before turning it on.

• AVOID UNINTENTIONAL

STARTING. Don't carry tool with

finger on switch. Be sure switch is

off when plugging in.

• EXTENSION CORDS. Make sure

your extension cord is in good

condition. When using an extension

cord, be sure to use one heavy

enough to carry the current your

product will draw. An undersized

cord will cause a drop in line

voltage resulting in loss of power

and overheating. The following

table shows the correct size to use

depending on cord length and

nameplate ampere rating. If in

doubt, use the next heavier gage.

The smaller the gage number, the

heavier the cord.

Minimum Gage for Cord Sets

Volts Total Lengthof Cord in Feet

120V 0-25 26-50 51-100 I01-150

240V 0-50 51-100 101-200 201-300

Ampere Rating

More Not more AWG

Than Than

0 - 6 18 16 16 14

6- 10 18 16 14 12

10 - 12 16 16 14 12

12 -16 14 12 NotRecommended

OUTDOOR USE EXTENSION

CORDS. When tool is used

outdoors, use only extension cords

intended for use outdoors and

so marked.

STAY ALERT. Watch what you are

doing. Use common sense. Do not

operate tool when you are tired.

CHECK DAMAGED PARTS.

Before further use of the tool, a

guard or other part that is damaged

should be carefully checked to

determine that it will operate

properly and perform its intended

function. Check for alignment of

moving parts, binding of moving

parts, breakage of parts, mounting,

and any other conditions that may

affect its operation. A guard or other

part that is damaged should be

properly repaired or replaced by an

authorized service center unless

otherwise indicated elsewhere in

this instruction manual. Have

defective switches replaced by

authorized service center. Do not

use tool if switch does not turn it on

and off.

SAVE THESE

INSTRUCTIONS

3

1 2 3 4 5 6 7 8 ... 30 31

Comments to this Manuals

No comments