Craftsman 358.797180 Operations Instructions download pdf (Page 9)

Shield -- lqlmmS

_WARNING

Failure to install the shield in the position shown in

Figures 8 and 9 can result in serious injury to the

operator. The length of the shield must be aligned with

the length of the drive shaft housing. Direct the widest

part of the shield toward the engine.

[CAlrriotq: t The Line Lhniter (on the underside

of the shield) is sharp and cancut you.

a. Match the Key (Raised area) on the Shield with the

Keyway ("V" slot) on the Drive Shaft Housing.

Figure 8 (inset).

b. Rest the bottom of the Shield on topofthe shoulder

of the Drive Shaft Housing above the Dust Cup.

WIDEST PART HARDWARE SHOWN

Ftgm_ 8

NOTE: The bottom of the Shield must rest on top of

the shoulder of the Drive Shaft Housing.

Install the Shield retaining Bracket and Screws as

shown in Figure 8.

NOTE: It is easier to start the Screws with a screw-

driver and finish tightening with a 3/8" wrench.

d. Tighten the Screws evenly and securely.

NOTE: A small space may be left between the

Bracket and the Shield when hardware is fully

tightened.

&ASSIST HANDLE -- Figures 9 & 10

a. Insert the end of the Drive Shaft Housingthrough

the Assist Handle. Figure 9 (inset).

b. Align the Assist Handle between the Safety Label

and the Throttle Trigger Housing. Seat the Drive

Shaft Housing in the groove in the Assist Handle.

Figure 9.

Insert the tab on the Assist Handle Bracket into

the slot on the Assist Handle. Figure 9. Then,

lay the Assist Handle Bracket over the Drive

Shaft Housing.

Bracket _,

Throttle

_'_ Trigger

Housing

Square

Nut

Groove

Label

Drive

T-Handle

_#/Assist Handle

sjScri

d. Drop the threaded end of the square-head T-

Handle Screw through the opening in the top of

.the T-Handle. Figure 10.

e. Pull on the threaded end of the Screwto bringthe

square head of the Screw past the pin inside the

T-H_dle. Figure t0.

f. Insert the Screw up through the hole in the Assist

Handle and then through the Assist Handle

Bracket. Figure 9.

g. Thread screw into square m,t. Tighten securely.

t CAUTION: I When adjusting the Assist Handle

for comfort, be sure that the Assist Handle re-

mains between Engine and Safety Label on

Drive Shaft Housing. Figure 9 •

h. Adjust Assist Handle up or down the Shaft Hous-

ing for comfort.

Before Assembly Top View

Assembled

T Handle

Square Head

Screw Seated

Figure 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Craftsman 358.797180 Operations Instructions Page 9

Comments to this Manuals

Related products and manuals for Power tools Craftsman 358.797180