Craftsman 358.797180 Operations Instructions download pdf (Page 18)

IllI I I iir IIIIIIIIIIIIIII

i i i ii lli,t

C. STARTER ROPE

Newr _rt the engine with the clutch shroud removM. The

cb_tch will fly apart and cause serious injury.

_WA/INING

Do not remove the retaining tab and screw to remove

pulley. The spring beneath the pulley is under tension

and can fly out causing serious injury. If any part of the

imlley t_ming assembly is damaged other than the rope,

do not use the tool. Take it to your Sears Service Center.

Disconnect Spark Plug Wire. Figure 28.

Remove the Screw and Nut in the Throttle Trigger

Housing as shown in Figure 2. Hold the Throttle Trigger

away from Drive Shaft Housing and remove Throttle

Cable from Trigger. Pall Cable out of Foam Grip

tunnel.

3. Remove the four Clutch Shroud Screws as shown in

Figure 28 with the small hex wrench provided.

4. Separate the Clutch Shroud fromthe Engine. Figure 29.

A DANG_JI

Use only a hand tool to remove the clutch. Do not use any

ffpe of mototized tool or strike the clutch in any way. Other-

wise, the clutch will fly apart and cause serious injury.

5. Hold the "Flats" ofthe Clutch with an adjustable wrench

as shown in Figures 29 and 30 and remove the Nut

counterclockwise with a 3/8" socket wrench.

NOTE: Clutch will slide offthe crankshaft intact. Do

not disassemble clutch.

6. Remove the Beveled Washer, Clutch and Large Flat

Washer as shown in Figure30.

7. Remove the Pulley Housing from the Engine. Figure 30.

8. Remove Rope Retention Screw. Remove any remain-

ing rope.

Hold Pulley Housing as shown in Figure 31. Hand turn

the Pulley clockwise as far as it will go. Then, turnthe

Pulley counterclockwise until the Pulley Notch is

aligned with the Housing Notch next to the Retaining

Tab and Screw. Figure 31. Next, turn the Pulley one

complete turn counterclockwise until the notches are

aligned again.

10. Insert the smallhex wrenchintothehole formed by

the Notches tohotd the Pulley in position. Figure 31,

11.

12,

Use a 42" length of replacement Rope.

Move away 10feet (3 meters) from the fuel tank with the

replacement Rope. Use a match and melt both ends of the

Rope to prevent fraying.

IIIaVlOVESCREa_

Shown without

Drive Shaft Homing

for clarity.

wigure28

ClJYlL_"FLA_"

CLUTCH

Fqure 29

PULLEY HOUSING

CLUTCH

LARGE

FLAT

WASHER

iiiii

BEVELED

WASHER

_CURVES

_AgD

CLUTCH)

NUT

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comments to this Manuals

No comments

Craftsman 358.797180 Operations Instructions Page 18

Comments to this Manuals

Related products and manuals for Power tools Craftsman 358.797180