MAINTENANCE
GENERAL
Only the parts shown on parts list, page 23, are intended to
be repaired or replaced by the customer. All other parts
represent an important part of the double insulation system
and should be serviced only by a qualified Sears service
technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
When electric tools are used on fiberglass boats, sports
cars, wallboard, spackling compounds, or plaster, it has
been found that they are subject to accelerated wear and
possible premature failure, as the fiberglass chips and
grindings are highly abrasive to bearings, brushes,
commutator, etc. Consequently, it is not recommended that
this tool be used for extended work on any fiberglass material,
wallboard, spackling compounds, or plaster. During any
use on fiberglass it is extremely important that the tool is
cleaned frequently by blowing with an air jet.
PROPER CARE OF CUTTERS
Get faster more accurate cutting results by keeping cutters
clean and sharp. Remove all accumulated pitchand gum from
cutters after each use,
When sharpening cutters, sharpen only the inside of the
cutting edge. Never grind theoutsidediameter, Be surewhen
sharpening the end ofa cutterto grind the clearance angle the
same as originally ground,
BRUSH REPLACEMENT
See Figure 31.
Your router has externally accessible brush assemblies that
should periodicallybe checked for wear.
PROCEED AS FOLLOWS WHEN REPLACEMENT IS RE-
QUIRED:
1. UNPLUG YOUR ROUTER.
2. Remove brush cap with a screwdriver. Brush assem-
bly is spring loaded and will pop out when you remove
brush cap.
3. Remove brush assembly (brush and spring).
4. Check for wear. If worn, always replace in pairs. Do
not replace one side without replacing the other.
5. Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
6. Replace brush cap and tighten securely.
Page18
PROPER CARE OF COLLET
From time to time, it also becomes necessary to clean your
collet and collet nut.To do so, simply remove collet nut from
toilet and clean the dustand chips that have collected. Then
return collet nut to its original position.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
BRUSH ASSEMBLY
BRUSH CAP
BRUSH CAP
Rg. 31
(24 pages)
(26 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals