_ WARNING: Do not allow familiarity with tools
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
_ WARNING: Always wear safety goggles or safety
glasses with side shields when operating power
tools. Failure to do so could result in objects being
thrown into your eyes resulting in possible serious
injury.
A
WARNING: Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
See Figure 2.
• Cutting Flush Joints
• Cutting Offset Joints
• Cutting Rabbeted Joints
Your router dovetail template kit has been designed for
cutting flush, offset, or rabbeted joints with speed and ac-
curacy. Since these joints are both strong and neat, they
are commonly used when making drawers and boxes.
Read all instructions carefully, and follow closely while
making set ups and adjustments.
FLUSH OFFSET RABBETED
JOINT JOINT JOINT
Fig. 2
NOTE: Once all adjustments have been properly made,
make a trial cut with scrap pieces of the same wood used
for the finished work.
This step allows you to check your adjustments. It also
makes you aware of the characteristics of the particular
wood being used.
MOUNTING DOVETAIL BASE
See Figures 3 - 4.
_ WARNING: For safe operation and proper
control, your router dovetail template kit must be
mounted to a workbench or table.
If desired, it can be clamped to a workbench with "C"
clamps, or it can be mounted onto a 3/4 in. piece of ply-
wood for mobility.
• Clamp the dovetail base to a workbench or table
with "C" clamps. It can then be easily removed upon
completion for easy storage or changing job sites.
CLAMP
C CLAMP
Fig. 3
A second, more preferred, method would be to mount
your dovetail base onto a piece of 3/4 in. plywood
approximately six inches wide and twenty-four inches
long. Position front of base flush with the front and
centered with the ends of the board, then insert four
flat head wood screws through holes in the base and
secure firmly into plywood. The dovetail base (with
wooden base) may then be clamped securely to
workbench or table with "C" clamps or other holding
apparatus. Here again, it can be easily removed upon
completion for easy storage or changing job sites.
WOOD
SCREWS
C CLAMP
PLYWOOD
Fig. 4
(32 pages)
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals