Craftsman 315.175010 Owner's Manual download pdf (Page 19)

MAINTENANCE

HOW TO REPLACE THE BLADE (Continued)

NOTE: Bade teeth point toward the dght of the plate

joinerwhen hem in normal operatingposition, The direc-

tion of €of•donismarked on the blade, An arrow on the

bottom of the front base assembly also indicates direc-

tion of rotation, See Figure 2Z

16, Tighten blade screw securely. NOTE: "rum blade

screw clockwiseto tighten,

17, Replace rear base assembly, Positionadjustment rod in

its proper place _zsshown in figure 28,

18. Secure rearhese assembly inplacewith the two spdngs.

Hook one end of each spring in notch on each side of

base assembly, Using needle nose pliers, stretch each

springand hook it over tabs on bearing plate,

19. Reassemble front base assembly.

20. Replace screws andtighten securelywith a screwdriver.

21. Remove screwdriver.

RIt;OvE T,&O.

ooTEo

_BLADE

Fig. 30

GENERAL

Only the parts shown on pads list, page twenty three, ere

intended to be repaired or replaced by the customer. All

other parts representan important part of the double insuia-

tion system and should be serviced only by a qualified

Sears service technician at an authorized service facility,

Avoid using solvents when cleaning plastic parts. Most

plastic_=are susceptibleto vadous types of commercial sot-

vents and may be damaged by their use. Use clean cloths

to remove dirt,dust, oil, grease, etc.

When electric toolsare used on fiberglassit has been found

that they are subject to accelerated wear and possible

premature failure, as the fiberglass chips and gtindingsare

highly abrasive to hearings, brushes, commutator, etc,

Consequently it is not recommended that this tool be used

for extended work on any fiberglass material, During any

use on fiberglass it is extremely important that the tool is

cleaned frequently by blowing with an air jet.

ACCESSORIES

THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND

WERE AVAILABLE AT THE TIME THIS MANUAL WAS PRINTED.

Item No, 9-25424 #O Blscults (5/8 in. • 1-13/16 in.) ................................................. Package of 50

Item NO. 9-25425 #10 Biscuits (13/16 In, x 2-1116 in.) ............................................... Package of 50

Item No. 9.25426 #20 Bllcuite (15/16 in. • 2-5/16 in,) ......;_ ...................................... Package of 50

_The use of attachments or accessories not listed above might be hazarrtous.

Page 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Craftsman 315.175010 Owner's Manual Page 19

Comments to this Manuals

Related products and manuals for Power tools Craftsman 315.175010