Craftsman 315.175010 Owner's Manual download pdf (Page 16)

OPERATION

TO INSTALL DUST BOX

See Figure 23,

1. Unplug your plate joiner.

2. Realigrldust poxwithmarof plate joiner, Groovesladust

box align with railson plate joiner.

3. Slide dust box on plate joiner as shown by the arrow in

figure 23, YOUwill feel a soft clickas the tabssnap into

place, NOTE: As mentioned previously, becareful not

to break the tabs that secure dust box to plate joiner,

GROOVES

DOS .°ox

Fig. 23

HELPFUL HINTS

/ Always clamp workplace securely before cutting.

/ A safe operator Is one who thinks ahead.

/ Always wear eye protectionwhen cutting slots.

/ Make set-upadjustments carefully.Then doublecheck.

Measure twice and cut once.

J Always dry assemble your project before gluing it

together.

,/ The more biscuits used, the strongerthe joint will be.

/ Keep blade clean and properly sharpened.

/ Don't let familiarity make you careless.

,/ Study all safety nJlasand do thejob safely.

/ NEVER place your hands injeopardy.

/ Make certain clamps can't loosen while in use.

/ Test dlfficuff set-ups on scrap--Don't waste lumber.

/ Plan each operation before you begin.

/ Provide for smoother operation by cleaning your plate

jolaer frsquendy. Sheke plete joiner or blowwith an air

Jetto remove wood particle build*up.

,/ dO NOT ABUSE POWER TOOLS. Abusive practioes

can damage tool as well as workpiece.

/ "n,IINK SAFETY BY THINKING AHEAD,

EXTENSION CORDS

The useofany extension cord willcause some loss of power,

TOkeep the loss to a minimumand to prevent tool overheat-

ing, followthe recommended cord sizes on the chart below.

When tool is used outdoo,'s,use onlyextension cords suit-

able for outdooruse and so marked. Outdoor useextension

cords are marked withthe letters 'WA" on the cord'sjacket,

Extension cords are available at Sears Retail Stores,

Extension Cord Length Wire Size A.W.G.

0-25 Feet 18

25-100Feet 16

t_rr_J_l Keep extension cords away from the cutting

area and positionthe cord so that it will not get caught on

lumber, tools, etc. dudngcutting operations.

LUBRICATION

All of the bearings inthis tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrica-

tion is required.

Page 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Craftsman 315.175010 Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Power tools Craftsman 315.175010