Craftsman 351.217450 Operator's Manual download pdf (Page 4)

Figure 3 - AssembleLegsto Frame

• Attach the long and short braces to the legs.

• Set stand upright on floor and tighten all bolts and

nuts firmly.

Figure5 - InstallingHandle

INSTALL DUST CHUTE

Refer to Figure 6,

• Slide dust chute over fan housing. Secure in position

with screw.

• Attach the Half Beg Dust Collection Set (included)

only after mounting planer/molder to stand.

Figure 4 - Assembled Stand

INSTALL HANDLE

Refer to Figure 5.

• Handle with knob is installedon the top rightof the

planer/molder.

• Insert handle with knob onto elevationscrew top.

• Secure handle with socket head bolt usingwrench

provided,

• Insert plug into handle to oover bolt.

Figure 6 - Installing Dust Chute

MOUNT PLANERJMOLDER TO STAND

Refer to Figure 7, page 5.

• Planer/molderis designed to be portable so it can be

movedto job site, but should be mountedto its

includedstand for stability.

• Make sure stand is located on a firm, level surface in

a place with ample lightingand correct power supply.

• Make sure there is plenty of room for movingthe

workpiece throughthe entire cut.There must be

enough room that neither the operatorsor the

bystanderswill have to stand in linewith the wood

while usingthe tool.

• Place the planer/molder on stand top.

CAUTION: Planer/molder weighs approximately150

Ibs.Two people may be required to liftplaner/molder.

1 2 3 4 5 6 7 8 9 ... 43 44

No comments

Craftsman 351.217450 Operator's Manual Page 4