Craftsman 486.248381 User Manual download pdf (Page 21)

STEP 48: (SEE FIGURE 47)

• Placethelifthandleintotheliftbracketontherightside

of the snow thrower. Fasten the handle to the bracket

using two 5/16" x 1-3/4" hex bolts (D) and 5/16" Nylock

nuts (CC).

FIGURE 48 RIGHT SIDE VIEW

LIFT RELEASE

CABLE

HEX NUT

LOCK

WASHER

HEX NUT

CABLE

WIRE

LIFT

ROD

TRIGGER

ASSEMBLY

NOTE:Besuretheliftreleasecable'splasticcovering

stays inserted into the trigger assembly for the next step.

STEP 49: (SEE FIGURE 48)

• Pushthelifthandledownintothelockedposition.

Insert the end of the cable wire into the hole in the

liftrod.Placethethreadedttingintotheslotinthe

liftbracket,withonehexnutaboveandonehexnut

and the lock washer below the slot. Tighten the nuts,

adjusting them to eliminate slack in the cable wire.

ReferalsototheServiceandAdjustmentssectionon

page 29 in this manual.

HINT: For easier assembly of the lift release cable, tilt the

snow thrower forward onto the spiral auger.

FIGURE 47 RIGHT SIDE VIEW

5/16" NYLOCK NUT (CC)

5/16" x 1-3/4"

HEX BOLT (D)

ASSEMBLY OF THE SNOW THROWER

STEP 50: (SEE FIGURE 49)

• Tiltthesnowthrowerbackdowntotheground.

• Removethenylontiewhichfastenstheauger

drivebelttothedischargehousing,leavingthebelt

assembled around the pulleys.

• Removethenylontiewhichfastensthechutecrank

rod to the crank rod support tube.

• Assemblethecrankrodsupporttubetothebracket

on the left side of the discharge housing using two

5/16" x 1-1/4" carriage bolts (M), and 5/16" Nylock

nuts (CC).

FIGURE 50 LEFT SIDE VIEW

CHUTE CRANK ROD

CRANK SUPPORT TUBE

TILT CONTROL HANDLE

5/16" x 1-3/4"

CARRIAGE BOLT (L)

BOWED WASHER (Y)

5/16" NYLOCK NUT (CC)

TILT

CONTROL

ASSEMBLY

STEP 51: (SEE FIGURE 50)

• Attachthechutetiltcontrolassemblytothetopside

of the crank support tube using two 5/16" x 1-3/4"

carriage bolts (L), bowed washers (Y) and 5/16"

Nylock nuts (CC).

5/16" NYLOCK NUT (CC)

5/16" x 1-1/4"

CARRIAGE BOLT (M)

CRANK ROD

SUPPORT TUBE

DISCHARGE

HOUSING

FIGURE 49 LEFT SIDE VIEW

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Comments to this Manuals

No comments

Craftsman 486.248381 User Manual Page 21

Comments to this Manuals

Related products and manuals for Cars Craftsman 486.248381