Craftsman Dual-Stage Snow Blower Tractor Attachment Owner's Manual download pdf (Page 11)

ATTACH CLUTCH IDLER ASSEMBLY TO TRACTOR

STEP 12: (SEE FIGURE 12)

• Attachtheclutch/idlerassemblytothetractorframe.

Hookthenotchedrearpulleyframebracketsontothe

twoshoulderboltsassembledtotheoutsideofthe

tractorframe.Liftthefrontoftheassemblyandattach

ittotheR.H.andL.H.hangerbracketsusingtwopivot

lockpinsand1/8"hairpincotters.

• Looselyattachthemowerclutchcabletotheleftside

of the tractor frame with a nylon tie. Do not pull the

nylontiecompletelytight.Thecablemayneedtobe

removedfromthenylontiewhenusingthemower

deck.

PIVOT LOCK PIN

(use this hole)

SHOULDER

BOLT

L.H. HANGER

BRACKET

1/8" HAIRPIN

COTTER

NYLON TIE

MOWER

CLUTCH

CABLE

FIGURE 12 VIEWED FROM LEFT SIDE

STEP 13: (SEE FIGURE 13)

• Assemblethedrivebeltontotheenginepulleyrst

and then onto the large pulley on top of the clutch/

idlerassembly.Thebeltmustbeplacedinsidethe

enginepulleybeltkeeper(s)andbetweenthelarge

pulleyandthekeeperboltnexttoit.

IMPORTANT: Do Notassemblethe"V"beltoutsideof

theenginepulleykeepersoroutsideofthekeeperbolt

nexttothelargepulley.

• Go to step 48 on page 22.

FIGURE 13 VIEWED FROM UNDERNEATH

ENGINE

PULLEY

ENGINE

PULLEY

Left Side

of Tractor

ENGINE

PULLEY

KEEPER

ENGINE

PULLEY

KEEPER

KEEPER BOLT

IDLER

PULLEY

FIGURE 11

STEP 11: (SEE FIGURE 11)

• Findthecableclipthatisattachedtotheleftside

of the tractor frame underneath the footrest. Open

theclipandremovethemowerclutchcable.Do not

removetheclipfromthetractorframe.Thecable

reattaches to the clip when using the mower deck.

• Movetheattachmentclutchleveronthedashpanelto

the disengaged position.

• Placetheclutch/idlerassemblyontheoorontheleft

side of the tractor.

• Attachthetractor'smowerclutchcabletothecable

bracketontheclutch/idlerassembly.Securethecable

housingguide(groovedown)tothecablebracket

usingtheoriginalcollaranda5/64"haircotterpin.

• Placea1/4"spacerontheweldedpinontheidler

arm.Hooktheendoftheclutchcablespringoverthe

pinandsecureitwitha1/4"washeranda5/64"hair

cotter pin.

• Aligncablebracketwithweldedpinandtightenthe

nutassembledinstep9.

5/64" HAIR

COTTER PIN

1/4" WASHER

1/4" SPACER

5/64" HAIR

COTTER PIN

TRACTOR'S

CLUTCH CABLE

CABLE

BRACKET

1 ... 10 11 12 ... 36

Comments to this Manuals

No comments

Craftsman Dual-Stage Snow Blower Tractor Attachment Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Snow throwers Craftsman Dual-Stage Snow Blower Tractor Attachment