Craftsman 320.18780 Operator's Manual download pdf (Page 24)

MAKING POCKET CUTS (Fig. 15)

WARNING: Always adjust the

bevel setting to zero before making

a pocket cut. Attempting a pocket

cut at any other setting can result in

a loss of control of the saw, which

can result in serious injury.

1. Adjust the bevel setting to

zero, set the blade to the

• Coi're_t blade-depth getting,

....and Use the lower blade guard

iever to swing the guard up.

Fig.15: __k_l. /_ if

;_: W_.RNING: Always raise the lower blade guard with the lever to avoid

serious injury.

2. While holding the lower blade guard up by the lever, firmly rest the front of

the saw base flat against the workpiece with the rear handle raised so the

blade does not touch the workpiece (Fig. 15).

3. Depress the lock-off button a[ld squeeze the trigger switch to start the saw.

Always le_tthe blade reach full speed, and then slowly lower the blade onto

' the workpiece,qntil the ba_se is flat against the Workpiece. As the blade

enters the material, youmust i;elease thelower blade guard lever.

4. After you complete the cut, release the trigger switch and allow the blade to

come to a complete stop. After the blade has stopped, remove_i,t,from the

workpiece. If the corners of you r p Qcket cut are not completelycut through,

use a hand finishing saw to finish the corners._ -

the

WARNING: Never tie the lower blade guard in the raised position. Leaving

blade exPoSed CQU!d result in serious ini_r;y.

18780 Manual_Revised_09-0513 -,Page 24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Craftsman 320.18780 Operator's Manual Page 24