Craftsman 315.268350 Operator's Manual download pdf (Page 23)

ROUTER TABLES

WARNING: Do not use with router tables

that fail to conform to safe wood working

practices and offer proper guarding for the cutter.

Failure to comply can result in an accident

causing possible serious injury.

If mounting your router to a router table, use only the

three 5/16-18 UNC-2B tapped holes provided in the

router base. Use 5/16-18 UNC-2A flat head screws that

are 1-1/8 in. or 1-1/4 in. long when mounting router to a

router table. NOTE: Router subbase must be removed

in order to gain access to the 5/16-18UNC tapped

holes.

,a,

WARNING: Do not use large router bits for

freehand routing. Use of large router bits when

freehand routing could cause loss of control or

create other hazardous conditions thatcouldcause

possible seriouspersonal injury.When usingrouter

table, large router bits should be used for edging

only.

,a,

WARNING: DO not use the four 8-32 UNC-2B

subbase screws or the 8-32 UNC-2B tapped

subbase screw holes for mounting router to a

router table. These screws and screw holes will

not secure router to router table properly and

could result in an accident causing possible

serious injury.

The use of Craftsman routers in router tables offered

by other manufacturers has not been investigated for

compliance with applicable safety standards.

HELPFUL HINTS

J Always wear eye protection when routing.

,/ A safe operator is one who thinks ahead.

•/ Plan each operation before you begin.

,f Study all safety rules and do the job safely.

J Don't let familiarity make you careless.

,f NEVER place your hands injeopardy.

,f Always clamp workpiece securely before routing.

J Make certain clamps can't loosen while in use.

•/ Make set-up adjustments carefully. Then double check. Measure twice and cut once.

J ProVidef_rsm__ther_perati_nbyc_eaningy_urmuterfrequent_y_Shaker_uter_rb__Wwithanairjett_rem_Ve

sawdust build-up.

J" Keep cutters clean and properly sharpened.

,f Check depth of cut settings carefully. Don't waste lumber by making too deep a cut. Make several shallow

passes, lowering the cutter for each new pass.

,/" Test difficult set-ups on scrap = Don't waste lumber.

_/ THINK SAFETY BY THINKING AHEAD,

Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Comments to this Manuals

No comments

Craftsman 315.268350 Operator's Manual Page 23

Comments to this Manuals

Related products and manuals for Power tools Craftsman 315.268350