Craftsman 137.218020 Operator's Manual download pdf (Page 12)

2. Liftupwardonripfencehandle(2)sotherear

holdingclamp(4)isfullyextended.

3. Placetheripfenceonthesawtable(5),engaging

therearfenceclampfirstthenloweringthefrontend

ontothetable.

4. Pushdownonthefencehandle(2)to lock.

Fig. E

Fig. H

o__ 2

2. Raise the blade arbor (4) (Fig. 1)to the maximum

height by turning the blade raising handwheel

counterclockwise.

3. Place the open-end wrench (8) jaws on the flats of

the saw arbor to keep the arbor from turning (Fig. J)

and place the box-end wrench (9) on the arbor nut

(5), and turn counterclockwise.

4. Remove the arbor nut (5) and outer flange (6) (Fig. 1).

INSTALLING AND CHANGING THE BLADE

(FIG. H, I, J)

DANGER I

• To avoid injury from an accidental start, make

sure the switch is in the OFF position and the

plug is not connected to the power source

outlet.

• To avoid serious injury, the rear of the table

insert must be level with the table. If the rear of

the insert is not level with the table, adjust the

screw (3) in or out until the rear of the insert is

level to or slightly above the table. To raise the

insert, turn the screw counterclockwise, to lower

the insert, turn the screw clockwise. NOTE: A

rubber adjusting spacer is provided under rear

of insert for this purpose.

Remove the table insert (1) by removing the two

screws (2, 3). Be careful not to lose the rubber

spacer that is on the back screw (3) beneath the

table insert (Fig. H).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

No comments

Craftsman 137.218020 Operator's Manual Page 12