Craftsman 351.21833 User Manual

Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A.www.sears.com/craftsman31624.00 Draft (10/08/09)Assembly Instructions10″CONTRACTO

STEP 19INSTALL PUSH STICK• Insert the push stick into brackets on left side of base.STEP 20INSTALL RIP FENCE• Position rip fence assembly at end of sa

11NOTES

® Registered Trademark / TM Trademark /SM Service Mark of Sears Brands, LLC ® Marca Registrada / TM Marca de Fábrica / SM Marca de Servicio de Sears B

2UNPACKINGThe table saw body comes assembled as one unit. Additionalparts which need to be fastened to the saw should be locatedand accounted for befo

3STEP 2• Use the blade tilt handwheel to tilt the blade completely to45°.• Remove the packing material from behind the motor.• Return blade to the 0°

4• Refer to Figure 7; loosen and remove the bolt and hex nutfrom the support. Rotate foot pedal bar so that kick platecam is inside bracket. The kick

5STEP 7ATTACH BASE TO CABINETTools Required: 8mm Hex WrenchHardware Required: Four M10 x 25 socket head bolts, four M10lock washers and four M10 flat

STEP 10ATTACH EXTENSION TABLESTools Required: 13mm Open End Wrench and Straight EdgeHardware Required: Six M10 x 25 hex head bolts, six M10lock washer

• Tighten the hex head bolts and lock washers very securely.This procedure will set the table and blade in parallel posi-tion and prevent the trunnion

• Attach brace to the far right end of the rails.Simultaneously slide brace with hex bolts into the rail T-slots and secure in position using lock was

STEP 17ATTACH BLADE GUARD AND ANTI-KICKBACKPAWLS• Place the slot of blade guard body over the riving knife.Slot of bushing is placed in the notch indi