Craftsman 315.228310 User Manual download pdf (Page 22)

ASSEMBLY

■ Get the front rail, the switch assembly, and the

following hardware:

6 square head bolts (5/16-18 x 1 in.)

6 flat washers (5/16 in.)

6 hex nuts (5/16-18)

2 screws (1/4-20 x 3/8 in.) (located on switch plate)

2 square nuts (1/4-20) (located on switch plate)

Right and left end caps for front rail

2 screws (5/32-32 x 1/2 in.)

■ Set aside end caps and screws until you have

aligned the rip fence and front rail.

■ Insert the six square head bolts into the table and

extensions, so the bolt heads extend outward 1/2

in.

■ Loosely attach a washer and a hex nut to each bolt.

■ The back of the rail has two slots. Slide the upper

slot over the bolts. (Bottom slot Is for switch.)

■ Align the rail left to right - Match the 7-1/8 in. mark

on the right scale to the right edge of the table saw

base (main table). See Figure 16.

■ Snug the rail against table. Finger-tighten each nut

on Uie table and extensions.

■ Locate the switch assembly. The two screws are

installed through the back of the switch plate with

the square nuts extending out toward the front.

Note: The square nuts are loose on the switch plate.

■ Slide the square nuts into the lower slot of the rail.

■ Slide the switch assembly to a convenient position,

leaving ample clearance for the handwheel. Tighten

securely with a screwdriver. Do not tighten the rail

bolts.

^ WARNING: Place the switch out of the

immediate work area to avoid accidentally

turning it off during operation.

INSTALLING THE FRONT RAIL

See Figures 15 and 16.

TABLE

SQUARE

HEAD BOLTS

TABLE

EXTENSION

Fig. 15

FRONT RAIL

END CAP

7-1Ain.MARK

RIGHT SCALE

ClIRFTSMIlir TABLE SAW 315.228310

Fig. 16

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Comments to this Manuals

No comments

Craftsman 315.228310 User Manual Page 22

Comments to this Manuals

Related products and manuals for Power saws Craftsman 315.228310