Craftsman 171.25490 Owner's Manual download pdf (Page 17)

II I1t1:1%.4..ILLI;Jt I,,'_ _IIVI;Illl !.1111;I L.II_.II;;II.II,._/I I0., I_.I l_l_.-J .-_s|_t,,.'_

being cut, then feed from LEFT TO RIGHT as stlown in

Figure 37.

away from the _arting pin, as shown by position #3 i_

Figure 39.

6. At this point, the piloted router bit is acting as a guide

and not the slatting pin. Feed the workplace against

' the rotatior, of cutter unlil the complete edge of the

workpiece has been cut. Then slide workplace away

Irom cutter.

Starting Pin

Workpiece Position #3 Position #2

FIGURE 37

FREE ROUTING IRREGULARLY SHAPED WORK

PIECES

For routing irregularly shaped work pieces, a starting pin

is provided. The starting pin is used for "free-routing"

witl_ piloted bits only, It Is not used for any other

operation described In this manual.

' 1 Remove the fence from the table.

2. Thread starting pin into tapped hole in the throat

plate, as shown in Figure 38, and tighten securely.

3. To free route with starting pin, orient workpiece on

table top against starting pin, as shown by position #1

in Figure 38. Workplace sl_ould not contact cutter.

4. Gradually swing workplace contacting pilot, swing

workpiece against tt_ecutter unti1111ocomplete edge

of the work piece has been cut. Then slide workpieca.

away from cutter.

Starting J°in

worl,; piece Position #2 Position #1

K @SDSC3EIN

CZtl "IIIIZ E]IZ EZ i

FIGURE 39

PROTRACTOR

Your protractor will sorve as a handy aid when extra suppo

is needed for routing sma!l workpieces or e_s o1'large

workpieces. See Figure 40.

Fence

Figure 40

Protractor

Workpiece

NOTE:, FOR ALL ROUTING OPERATIONS REQUIR-

ING USE OF,MITER GALIGE ALONG WITH

THE EENCE, BE SURE TO ALIGN FENCE

_,_ITHMITER 'BAR SLOT-BEFORE MAKING

ANy :CUTS. SEE FIGURE 24.

1 ... 16 17 18 19

Comments to this Manuals

No comments

Craftsman 171.25490 Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Networking Craftsman 171.25490