Craftsman 139.53637SRT Owner's Manual download pdf (Page 33)

Children operating or playing with a garage

door opener can injure themselves or others.

The garage door could close and cause

serious injury or death.

Do not allow children

to operate the wall push button(s) or remote

control(s).

A moving garage door could injure or kill

someone under it.

Activate the opener only

when you can see the door clearly, it is free of

obstructions, and is properly adjusted.

Models with 3-function remote controls: The

remote control(s) has been factory set to operate

with the

large

push button. However, you can use

either of the two small buttons, if you prefer. And,

the 3-function remote control(s) can also activate

additional garage door openers and/or light controls.

Below are instructions for programming your opener

to match the other buttons on your remote controls

and any additional remote controls you may

purchase. See available accessories on page 38.

Models with a single-function remote control:

The garage door will operate when you press the

remote control push button. Refer to the information

below if you want to add a 3-function remote control

or erase your programmed code.

Your "SRT" garage door opener will operate with as

many as four "SRT" portable remote controls and

one Multi-Function Keyless Entry.

To Add A Remote Control

1. Select a remote control push button to operate

the receiver.

2. Press and

hold

the selected remote control push

button, Figure 1.

3. Then press and release the "SRT" button on the

back panel of the opener, Figure 2. The opener

light will

flash once.

Now the opener will operate when the remote

control push button is pressed.

If you release the remote control push button

before the opener light flashes, the opener will

not accept the code.

To Change the Selected Push Button

On the Same Remote Control

If you decide to use a different remote control button

than originally programmed into the opener, you

need to erase

all

the learned codes and reprogram

each remote control used to operate the garage

door opener.

To Erase All Remote Control Codes

• Press and hold the "SRT" button on the opener

panel until the indicator light turns off (about 6

seconds).

All

the codes the opener has learned

will be erased.

• To reprogram, repeat Steps 1, 2 and 3 for each

remote control in use.

Select a remote control push

button to operate opener

"SRT"

Button

Indicator

Light

53000SRT Series Garage Door Openers

(With "SRT" Button)

Code programming instructions are also located

on the opener panel.

Figure 2

Figure 1

Standard 3-Function Remote Control

Mini 3-Function

Remote Control

Single Function

Remote Control

Garage Door Opener

(With "SRT" Button)

WARNING

Receiver and Remote Control Programming

To comply with FCC rules, adjustment or modifications of this

receiver and/or transmitter are prohibited, except for changing

the code setting or replacing the battery. THERE ARE NO

OTHER USER SERVICEABLE PARTS.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Craftsman 139.53637SRT Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 139.53637SRT