Craftsman EZ3 917.258990 Owner's Manual download pdf (Page 26)

SERVmCE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

o Raise hood,

• Pult bulb holder out of the hole in the backside of the

grill

. Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

• Close hood

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run

poorly, stop running, or prevent it from starting

• Check wiring. See electrical wiring diagram in the

Repair Parts section of this manual

• "4

"HEADLIGHT

J '. WIRE

HOOD _ ' "` CONNECTOR

FIG. 36

TO REPLACE FUSE

Rep{ace with 30 amp automotive-type plug-in fuse,, The

fuse holder is located behind the dash°

TO ADJUST ATTACHMENT LIFT SPRING

(See Fig. 35)

• While holding spring bushing with wrench, loosen jam

nut,

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

(See Fig, 37)

The throttle control has been preset at the factory and

adjustment should not be necessary. Check adjustment as

described below before loosening cable If adjustment is

necessary, proceed as follows:

. Turn adjustment bolt clockwise to extend spring and

reduce lift effort for heavier attachments,

,, Turn adjustment bolt counterclockwise for lighter at-

tachments.

° Retighten jam nut against spring bushing,

IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING

TENSION WHEN USING LtGHT ATTACHMENTS SUCH

ASAMOWER ADJUST LiFT LEVER SPRING TO AID iN

LIFTING ATTACHMENT, DO NOTOVERPOWER SPRING.

WHEN REMOVING ATTACHMENT, ALWAYS ADJUST

SPRING TENSION TO ITS LOWEST POSITION

ADJUSTMENT

SPRING BUSHING

0 ATTACHMENT

JAM NUT LIFT SPRING

FIG. 35

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig, 36)

Raise hood,

,, Unsnap headlight wwe connector

" Stand m front of tractor Grasp hood at sides, tiIt toward

engine and lift off of tractor.

° To replace, reverse above procedures

With engine not running, move throttle conhol lever to

fast ('_) position

Check that speed control lever is against stop screw. If

it is not, loosen casing clamp screw and pull throttle

cable until lever is against screw. Tighten clamp screw

securely.

IDLE FUEL

ADJUSTING IDLE SPEED

NEEDLE

SCREW

THROTTLE

CONTROL

CABLE

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Comments to this Manuals

No comments

Craftsman EZ3 917.258990 Owner's Manual Page 26

Comments to this Manuals

Related products and manuals for Tractor Craftsman EZ3 917.258990