Craftsman C950-52930-0 User Manual download pdf (Page 12)

OPERATION

Get to know your snow blower and its controls. Be sure you (or any other operator) have read and understood the Operation

Precautions listed on page 2 of this manual.

Primer Button

Carburetor

Cover

Oil Fill Cap/Dipstick

Traction Drive

Auger Drive Clutch Lever

Clutch Lever

Auger

Select

Lever

Traction Drive Cable

Remote Chute Control

Choke \

Ignition Key

Throttle Control

Lever

Starter Handle

Headlight

Assembly

Toolbox

Height

Adjust Skid

Snow Chute

Deflector Auger Housing

Figure 13

ENGINE AND SNOW BLOWER OPERATING CONTROLS

The engine operating controls and their functions are as

follows:

Throttle Control Lever - This snow blower is equipped with

an engine mounted throttle control lever used to start a cold

engine.

Choke Lever- Set choke lever to ON CHOKE position to

start a cold engine.

Electric Start Button- Used to start the engine using the

120 volt electric starter.

Prime Button- Used to inject fuel directly into carburetor

manifold to insure fast starts in cool weather.

Ignition Key- Must be inserted into ignition key slot to start

engine. Pull out to stop. Do not turn ignition key.

Starter Handle- Starts the engine manually.

The snow blower operating controls and their functions

are as follows:

Speed Select Lever- Allows the operator to use one of six

(6) forward and two (2) reverse speeds. To shift, move speed

select lever to desired position.

F-001008J 12

NOTE: Do not move speed select lever while Traction

Drive Clutch is engaged. This may result in severe

damage to drive system.

Auger Drive Clutch Lever- Used to engage and disengage

the auger and impeller. To engage push down, to disengage

release.

Traction Drive Clutch Lever- Used to propel snow blower

forward or reverse. Push down to engage, release to

disengage.

Snow Chute Deflector- Changes the direction the snow is

blown.

Remote Chute Deflector Lever- Push remote lever forward

to discharge snow high and far. Pull remote lever back to

discharge snow down.

Crank- Used to change direction of the snow discharge.

Turn handle clockwise to turn chute to right. Turn handle

counter clockwise to turn chute to left.

Height Adjust Skid- Used to adjust ground clearance of

auger housing (see To Adjust Skid Height in the

Adjustment/Repair section of this manual).

Toolbox - Spare shear pins and spacers are located in

toolbox.

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS

NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 91 92

Comments to this Manuals

No comments

Craftsman C950-52930-0 User Manual Page 12

Comments to this Manuals

Related products and manuals for Snow throwers Craftsman C950-52930-0