Craftsman CompuCarve 133.217540 Operations Instructions download pdf (Page 190)

189

CarveWright Designer Software Manual

Drawing Menu

Pointer Tool:

Select this tool, then left-click on the board to select carvings for manipulation. You may hold down

the SHIFT key to select or de-select additional carvings. You may also click and drag to draw a wire-

box to select multiple carvings.

Line Segment Tool:

Select this tool, then left-click on the board to begin a line segment. Left-click again to end it. You

may also click and drag to create a segment.

Connected Lines Tool:

Select this tool, then left-click on the board to begin a line segment. Each successive left click ends

the previous segment and begins a new one. To end the segments, you may either double-click to

place a nal segment, click on the last vertex placed, press the ESC key, or click on the rst vertex

to create a closed loop.

Spline Tool:

Select this tool, then left-click on the board to begin a curved segment. Each successive left click

ends the previous segment and begins a new one. You need to create two or more connected

segments to see the curve effect. To end the segments, you may either double-click to place a nal

segment, click on the last vertex placed, press the ESC key, or click on the rst vertex to create a

closed loop.

Square Tool:

Select this tool, then left-click on the board to start a square, and then left-click again to end it.

You may also click and drag to create a square. Squares will maintain their square aspect when

manipulated.

Rectangle Tool:

Select this tool, then left-click on the board to start a rectangle, and then left-click again to end it. You

may also click and drag to create a rectangle.

Circle Tool:

Select this tool, then left-click on the board to place the center of the circle, then left-click again to

end it. You may also click and drag to create a circle. Circles will maintain their circular aspect when

manipulated.

Oval Tool:

Select this tool, then left-click on the board to place the center of the oval, then left-click again to end

it. You may also click and drag to create an oval.

Arc Tool:

Select this tool, then left-click on the board to place one end of the arc, then left-click to place the

other end. You may also click and drag to create an arc. Either way you need to click and drag the

Green Control Point to change the radius of the arch.

Spiral Tool:

Select this tool, then left-click to place a spiral. It may then be manipulated by dragging the yellow

border to widen the loops or by dragging its vertices to set the starting and ending loops.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 218 219

No comments

Craftsman CompuCarve 133.217540 Operations Instructions Page 190