Craftsman CSD40QU Owner's Manual download pdf (Page 5)

TECHNICAL DATA

OPERATING INSTRUCTIONS

41771 4V screwdriver

Charger voltage

Rated voltage

Battery capacity

Rated speed

Max torque

Machine weight

Charging time

Charger protection class

Charger output

120 V~ 60Hz

4 V

1.5 Ah Li-ion

180 /min

31 inch-lbs

1.05 lbs

3-5 hours

II/

5 V 500 mA

NOTE:

Before using the tool, read the instruction book carefully.

Intended Use:

The power tool is intended for driving in and loosening

screws as well as for drilling in wood, metal and plastic.

Inspect the Screwdriver before using to ensure all the parts are running smoothly

and there are no abnormal sounds or sparks.

WARNING: Before using screwdriver to drive fasteners into walls, check

behind walls for wire and other electrical shock hazards or plumbing.

OPERATING INSTRUCTIONS cont.

BEFORE OPERATING THIS TOOL

A) CHARGE THE BATTERY

The battery charger supplied is only for the Li-ion battery installed in the

tool. Do not use another battery charger. The Li-ion battery is protected

against deep discharging. When the battery is empty, the tool is

switched off by means of a protective circuit: The tool will not turn on when the

trigger is engaged. When the Battery Pack is charged for the first time or after

prolonged storage, the Battery Pack will accept a 100% charge only after

several charge and discharge cycles.

B) CHARGING (See Fig. 3)

Plug the charger plug into a suitable

power outlet. Next, connect the

charger to the Charging Socket on the

screwdriver; the indicator will illuminate

Red during charging. Let the battery

charge for 3-5 hours. The battery is fully

charged as soon as the indicator changes

to Green. Then unplug the charger.

Disconnect the Charger from the

screwdriver. The screwdriver is ready to

be used.

Important: When charging, the charger and screwdriver may become

warm to the touch; this is normal and does not indicate a problem.

SELECTING A BIT

Pull the Slide button back (1) completely. Manually rotate the Bit Cartridge

counterclockwise until the desired bit appears in the top window (2).

Push the Slide button forward (3) completely. (SEE Fig. 4 & 4A). The magnetic

chuck will hold the bit firmly in place.

(Fig. 3)

(Fig. 4A)

(Fig. 4)

NOTE: The Screwdriver will not operate if the Slide button is not fully pushed

into the forward position.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Craftsman CSD40QU Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Craftsman CSD40QU