Craftsman C935.51850 Operator's Manual download pdf (Page 5)

ASSEMBLY TOOLS REQUIRED (NOT

SUPPLIED):

- Phillips Screwdriver

ATTACHING THE TWO PIECE

GUARD

WARNING: UNPLUG THE TOOL

BEFORE ATTEMPTING TO ATTACH

THE GUARD. NEVER OPERATE TOOL

WITHOUT GUARD FIRMLY IN PLACE.

THE GUARD MUST ALWAYS BE ON

THE TOOL TO PROTECT THE USER.

• Remove the two guard sections from

the carton.

• Attach the first guard section with side

tab into the groove around the housing

as shown in figure 1. Align the hole in

the guard with the post on the trimmer

housing.

• Remove the screw from the second

guard section.

• Insert the top tab from the second

guard section into the first guard

section as shown in figure 2. NOTE:

The rib behind the tab should be

hooked over the rib of the first guard

section. (See inset figure 2).

• Insert the side tab from the first guard

section into the slot of the second guard

section until you hear them “snap”

together (figure 3).

• Insert the

3

/4

inch (19mm) screw as

shown in figure 4 to complete the guard

assembly.

• Once the guard is installed, remove the

covering from the line cut-off blade, located

on the edge of the second guard section.

ATTACHING THE EDGE GUIDE

• Remove the edge guide from the carton.

• Insert one end of the guide into the hole

in the housing as shown in figure 5.

• Pull the other end of the guide over until

it slips in opposite hole in housing

(figure 6).

• Rotate guide back against housing as

shown in figure 7. NOTE: Guide should

lay flat flat to the plastic housing as

shown in the illustration.

4

ASSEMBLY INSTRUCTIONS

1

2

3

Slot

Tab

Tab

Rib

Tab

1 2 3 4 5 6 7 8 9 10 ... 35 36

Comments to this Manuals

No comments