Craftsman C935.51850 Operator's Manual download pdf (Page 4)

SAFETY WARNINGS: DOUBLE INSULATION

Double insulated tools are constructed

throughout with two separate layers of

electrical insulation or one double

thickness of insulation between you and

the toolʼs electrical system. Tools built

with this insulation system are not

intended to be grounded. As a result,

your tool is equipped with a two prong

plug which permits you to use extension

cords without concern for maintaining a

ground connection.

NOTE: Double insulation does not take

the place of normal safety precautions

when operating this tool. The insulation

system is for added protection against

injury resulting from a possible electrical

insulation failure within the tool.

Replacement parts: When servicing all

tools, USE IDENTICAL REPLACEMENT

PARTS. Repair or replace damaged

cords.

SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS

To reduce the risk of electric shock, this

equipment has a polarized plug (one

blade is wider than the other). This

equipment must be used with a suitable

polarized 2 wire or 3 wire extension cord.

Polarized connections will fit together

only one way. Make sure that the

receptacle end of the extension cord has

large and small blade slot widths. If the

plug does not fit fully into the extension

cord, reverse the plug. If it still does not

fit, obtain a suitable extension cord. If the

extension cord does not fit fully into the

outlet, contact a qualified electrician to

install the proper outlet. Do not change

the tool plug or extension cord in any

way.

of moving parts, binding of moving parts,

breakage of parts, mounting, and any

other condition that may affect its

operation. A guard or other part that is

damaged should be properly repaired or

replaced by an authorized service center

unless otherwise indicated elsewhere in

this manual.

WARNING: When servicing double

insulated tools, USE ONLY IDENTICAL

REPLACEMENT PARTS. Replace or

repair damaged cords.

WARNING: To prevent electrical shock

hazard, use only with an extension cord

suitable for outdoor use. Always connect

extension cords to a fused line or one

protected by a circuit breaker.

WARNING: To reduce the risk of electric

shock use only with an extension cord

intended for outdoor use, such as SW-A,

S0W-A, STW-A, STOW-A, SJW-A,

SJOW-A, SJTW-A or SJTOW-A.

• EXTENSION CORD. Make sure your

extension cord is in good condition.

When using an extension cord be sure it

is heavy enough to carry the current your

product will draw. An undersized

extension cord will cause a drop in line

voltage resulting in loss of power and

overheating. The following table shows

the correct size to use depending on cord

length and nameplate ampere rating. If in

doubt, use the next heavier gage. The

smaller the gage number, the heavier the

cord.

ADDITIONAL WARNINGS FOR

STRING TRIMMERS

1. DO NOT immerse tool in water or

squirt it with a hose. DO NOT allow

any liquid to get inside it.

2. Do not store the tool on or adjacent to

fertilizers or chemicals.

3. DO NOT clean with a pressure washer.

Minimum Gage for Extension Cords (AWG) 120

VAC Tools

Total Cord Length 0-25 26-50 51-100 105-150

Amp Rating AWG AWG AWG AWG

More than 0 18 16 16 14

Not More than 6

More than 6 18 16 14 12

Not More than 10

More than 10 16 16 14 12

Not more than 12

More than 12 14 12 Not

Not more than 16 Recommended

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments