Craftsman 351.217040 Operator's Manual download pdf (Page 8)

Figure 6 - Functions of the Digital Scale

• This scale uses a 1.55 volt battery cell (SR44). If it

needs replacing, slide off the battery cover and

insert the battery, with the positive pole of the bat-

tery facing out.

NOTE: After replacing a battery, the digital display set-

tings should be recalibrated.

BUTTON FUNCTIONS

ON/OFF/ZERO - Power and Zero Setting

• Press ON/OFF/ZERO button no longer than three (3)

seconds to power on.

• Press ON/OFF/ZERO button at least three (3)

seconds to shut off the digital display.

• While in relative mode, press ON/OFF/ZERO (no

longer than three (3) seconds to set current position

as relative zero point.

• While in absolute mode, press ON/OFF/ZERO (no

longer than three (3) seconds to set current position

as absolute zero point.

ABS - Relative/Absolute Modes

• The scale is in absolute mode as soon as power is

turned on, and displays absolute zero. Moving the

planer table up and down begins absolute measure-

ment. Absolute measurement is usually set based

upon the distance from cutterhead to table.

• Press ABS button (no longer than three {3} seconds)

to switch to relative mode. "INC" will appear on the

display. The value shown is in relative mode. Moving

the table up and down will now display relative mea-

surement.

MM/INCH - Millimeters/Inches

• Pressing this button toggles back and forth between

standard and metric, and can be done at any time

without affecting saved settings.

HOLD - Maintains Data On The Display

• Press this button to "freeze" a measurement on the

display; it will remain even if the table is moved.

Press HOLD again and it returns to normal

measurements.

SET - Preset a Value

• Press SET; the indicator will flash "SET". Press and

hold the SET button and each digit flashes in turn.

When the digit you want flashes, release the SET

button.

• Press SET button once (no longer than one {1}

second) and that digit will increase by one each time

SET is pressed. When finished, press and hold SET

button until indicator "SET" flashes, then press SET

again (no longer than one {1} second). The indicator

"SET" disappears and the value you just input is

displayed on the screen.

• From this point on, any table movement will be

based off this setting. The setting will be kept in the

device's memory, even when the digital display is

turned off.

TOL - Tolerance Setting

• Press TOL and an up-arrow indicator will appear, as

well as a flashing "SET" indicator. You can now

change the upper tolerance limit.

• Hold down the TOL button and each digit flashes in

turn. When the digit you want flashes, release the

TOL button.

• Press TOL button once (no longer than one {1}

second) and that digit will increase each time TOL is

pressed.

• When finished, press and hold TOL button until

indicator "SET" flashes. While indicator "SET" is

flashing, press SET button to change the arrow to

the down-arrow indicator. You can now change the

lower tolerance limit in the same manner as you

changed the upper tolerance limit.

• When finished setting the lower tolerance limit,

while indicator "SET" is flashing, press SET button

(no longer than one {1} second). The device is now

in tolerance measuring mode. When the up-arrow

indicator is displayed, it means the measured value

is beyond the upper limit. When the down-arrow

indicator is displayed, the measured value is below

the lower limit. When the display shows an "OK"

indicator, the measured value is within tolerance.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments

Craftsman 351.217040 Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Craftsman 351.217040