Craftsman 320.28102 Operator's Manual download pdf (Page 17)

I. OTE: A significantly reduced run time after fully charging the battery pack indicates

that the batteries are near the end of their usable life and must be replaced.

COLD WEATHER OPERATION

[] This Lithium-Ion battery pack will provide optimal performance in temperatures between 32°F

(0°C) and 104°F (40°C)., When the battery pack is very cold, it may "pulse" for the first minute

of use to warm itself up. Put the battery pack on a tool and use the tool in a light application°

After about a minute, the battery pack wilt have warmed itself up and will operate normally.

WHEN TO CHARGE THE BATTERY PACK

The Lithium-Ion battery can be charged at any time and will not develop a "memory" when

charged after only a partial discharge. It is not necessary to run down the battery pack charge

before recharging Remove the battery pack from the tool when convenient for you and your job,_

[] Use the POWER BAR to determine when you need to recharge the battery pack.

[] You can "top-off" your battery pack's charge before starting a big job or long period of use,.

[] Due to Lithium-Ion's fade-free properties, the only time it is necessary to charge the Lithium-

Ion battery pack is when the pack has reached the end of its charge. To signal the end of

charge, power to the tool will drop quickly. Charge the battery pack as needed.,

HOW TO CHARGE THE BATTERY PACK

NOTE: This Lithium-Ion battery pack is shipped partially charged, Before using it the [first time, fully charge the battery pack.

A fully discharged battery pack with a temperature between 32°F (0°C) and 104°F (40°C) will

charge in about 50 minutes,

[] Charge the Lithium-lon battery pack only

with the correct charger

[] Connect the charger to a power supply.

[] Attach the battery pack to the charger by

aligning the raised ribs of the battery pack

with the slot in the charger, Slide the battery

pack onto the charger (Fig. 3)

[] The charger wilt communicate with the

battery pack's SmartChip TM circuitry to

evaluate the condition of the battery pack.,

[] The POWER BAR LED lights will cycle from

right to left during charging, This is part of the

normal charging operation.

[] After charging is complete, the green LED

on the charger will come on and the POWER

BAR LED lights will go offr The POWER BAR

LED lights will not be displayed when the

POWER BAR button is pressed while the

battery pack is on the charger.

[] The battery pack wilt fully charge, but will not

overcharge, if left on the charger.

NOTE: For your convenience, the charger can operate with most generators and

inverters rated at 300 watts or higher.

'I7

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Comments to this Manuals

No comments

Craftsman 320.28102 Operator's Manual Page 17

Comments to this Manuals

Related products and manuals for Power tools Craftsman 320.28102