Craftsman 320.28102 Operator's Manual download pdf (Page 16)

POWER BAR

[] This Lithium-Ion battery pack is equipped with a POWER BAR which is used to display the

battery pack's remaining run time_ Press the POWER BAR button to display the LED lights. The

LED lights will stay lit for approximately 4 seconds.

NOTE: The POWER BAR can be used when the battery is attached or removed from tool,J

Fig, 2

000@

0000

ooo÷

80-100%

Charge

60-79%

Charge

40-59%

Charge

20-39%

Charge

Under 10%

Charge

Completely

discharged

LOW CAPACITY WARNING

[] If one LED on the POWER BAR begins to flash, the battery pack's charge is under 10%

capacity and should be recharged_

[] Unlike other battery pack types, Lithium-ion battery packs deliver fade-free power for their

entire run time° The tool will not experience a slow, gradual toss of power as you work. To

signal that the battery pack is at the end of its run time and needs to be charged, power to the

toot will drop quickly.. The POWER BAR will begin to display four flashing LED lights when it is

comptetely discharged_ When this happens, remove the tool from the workpiece and charge

the battery pack as needed°

NOTE: The POWER BAR may also display four flashing LED lights due to an overload |

or high temperature situation (see SmartChip TM Battery protection).

SmartChip TM BATTERY PROTECTION

SmartChip TM intuitive circuitry protects the battery pack from extreme temperature, over-discharge

and over-charge. To protect the battery from damage and prolong its life, the battery pack's

SmartChip TM circuitry wilt turn off the battery pack if it becomes overloaded or if the temperature

becomes too high during use_ This may happen in extremely high torque, binding and staliing

situations° This intelligent system will shutdown your battery pack if its operating temperature

exceeds 176°F (80°C) and wilt begin normal operation when it returns to 32°F (0°C) - 122°F (50°C).

[] The POWER BAR wilt display four flashing LED lights if the SmartChip TM circuitry detects a

momentary overload° You can conveniently reset the battery pack by pressing the POWER

BAR button. Press the POWER BAR button again to display the remaining charge.

NOTE: If the POWER BAR continues to flash four LED lights after reset, place the I

battery pack on the charger to evaluate the battery condition (see Fig. 4).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Craftsman 320.28102 Operator's Manual Page 16

Comments to this Manuals

Related products and manuals for Power tools Craftsman 320.28102