Craftsman 320.17234 Operator's Manual download pdf (Page 13)

BLADE STORAGE (Fig. 3 and 4)

Your sabre saw comes witl_ 2 wood cutting blades that are stored in the blade storage

compartment located on the very back of the saw under the power cord inlet (see Fig. 3)

To open blade storage door, remove the vac adapter tube (see Fig. 4). Lift the vac

adapter tube up siightty (to release tab from base plate) and pull vac adapter tube

straight out to remove. Pull tab on blade storage door down to open and turn saw upside

fown to remove blades (see Fig 3)..

Fin 3 X I

=" _OmrPar,ment .4%_._f ...-_-.J

Remember to always use the proper blade for the material being cut.

TOOL-LESS BLADE

INSTALLATION (Fig, 5, 6 and 7)

Tool-less blade change allows you to

remove and replace the saw blade quickly

and easily without the use of additional tools.

1, Unplug the saw..

Z_ WARNING; ALWAYS unplug saw

from the power source before changing

blades or making any adjustments.

Failure to unplug the saw could result in

accidental starting which can cause

serious personal Injury°

2o Raise up the clear chip shield, lift one side out

of its mounting s$ot, and remove the shield

from the saw (see Fig. 5). Appty a little force

when lifting and removing the shield from the

saw

3oTurn the saw upside down so you have access

to the blade holder assembly.

4..Rotate the "black" cover on the blade holder

assembty counterclockwise about a quarter

turn and hold it in this position while inserting

a blade into the slot of the blade holder

(see Fig 6) The teeth of the blade should be

facing to the front and point up, and the back

of the blade must rest in the groove of the

blade guide roller (see Fig 7)°

5. Release the "black" cover on the blade holder

assembly to lock the blade in place

(see Fig. 6, Fig 7 )o

Fig. 7

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

No comments

Craftsman 320.17234 Operator's Manual Page 13