Craftsman 315.SS630 Operator's Manual download pdf (Page 11)

Motordoesnotrun.

Motoroverheats.

MotorhasaUowhumbutdoesnot

spray.

Motorseemsto berunningproperty

butdoesn'tspray.

SprayedmateriaUisspitting,gUobbing

uporunabUeto getapreferredspray

patternwithanevenamountofpaint

orstain

CAUSE

Battery is not charged.

Piston has seized up.

Continuous spray operation.

Piston has seized up.

Suction tube and fluter are Uooseor

damaged.

Atomizer vaUveis cUogged or worn

out.

MateriaU being sprayed is too thick.

PUugged spray tip or intake fluter;

worn piston.

Paint container voUume is getting Uow.

MateriaU being sprayed is too thick.

Suction tube is Uoose.

Atomizer vaUveis cUogged or worn

out.

POSSIBLE SOLUTmON

Charge battery.

ThoroughUy cUeanthe sprayer using long-

term storage cleaning instructions in the

Maintenance section of this manual.

Release trigger at the end of each pass

to allow the motor to cool.

Thoroughly clean the sprayer using long-

term storage cleaning instructions in

the Maintenance section of this manual.

Reinstall or replace suction tube and

filter as needed.

Clean or replace atomizer valve.

Follow material manufacturer's direc-

tions and thin material as needed.

Thoroughly clean the sprayer and, if

necessary, replace piston*, using stor-

age cleaning instructions in the Mainte-

nance section of this manual.

Refill paint container.

Follow material manufacturer's direc-

tions to thin material as needed.

Reinstall suction tube securely.

Clean or replace atomizer valve.

Worn spray tip or piston. Clean or replace spray tip or piston*.

Paint/stain spray overspray is exces- Spray tip is too far from the surface Hold sprayer closer to the surface being

sive. being sprayed, sprayed.

Paint/stain runs or sags on the work Proper paint methods not being Refer to Operating the Sprayer earlier

surface, observed, in this manual.

Paint/stain is leaking behind the Spray tip is loose. Tighten spray tip.

spray tip. Atomizer valve is worn or not posi- Replace or reposition atomizer valve as

tioned properly, needed.

* Although unlikely, a worn piston is possible. A replacement piston can be purchased by cafling customer service at

1-800-932-3188. Follow the instructions in Cleaning the Sprayer for Storage to access the piston for replacemenL

11 - English

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Craftsman 315.SS630 Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Power tools Craftsman 315.SS630