Craftsman 17" Drill Press with Laser and LED Light Owner's Manual download pdf (Page 9)

5. Installing the chuck

WARNING: Before any assembly of the chuck and arbor to the drill

press head, clean all mating surfaces with a non-petroleum based

product; such as alcohol or lacquer thinner. Any oil or grease used

in the packing of these parts must be removed; otherwise the chuck

may come loose during operation.

5.1 Open the jaws of the chuck by rotating the chuck sleeve clockwise.

To prevent damage, make sure the jaws are completely receded into

the chuck.

5.2 Push the chuck shaft into the spindle.

5.3.Use a wooden mallet to rmly tap the chuck securely into place in the

spindle. See Fig. 6.

NOTE: To remove chuck perform the following:

- Rotate the chuck sleeve clockwise until the jaws recede completely into

the chuck.

- Lower the spindle as far as it will go to reveal the spindle slot. See Fig.6A

- Raise the table to a position just below the the chuck.

- Insert the tip of the chuck removal tool into the spindle slot above the tip

of the chuck shaft.

- Tap on the blunt end of the wedge tool until the chuck releases from the

spindle.

6. Install knob for the head assembly lid. Fig. 7

7. Flexible lamp

Install the exible lamp

7.1. Connect the lamp plug contact to the power source plug contact in

the drill head as shown.

7.2. Use four pan head screws to install the lamp assembly to the drill

head as shown.

7.3. Turn on the exible lamp switch to check the lighting. Fig. 8

Figure 6

ASSEMBLY

Flex lamp

switch

Plug

contact

Pan head

screw

Figure 8

Knob

Figure 7

Figure 6A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

No comments

Craftsman 17" Drill Press with Laser and LED Light Owner's Manual Page 9